Your cart is empty.
Your cart is empty.Product Description
Front/Rear signal light for Kawasaki Vulcan VN
Motorcycle Front/Rear signal light for Kawasaki Vulcan VN 750 800 900 1500 1600 1700 2000
Every element of our turn signal has been constructed with an emphasis on durability and reliability
Rear left rear right or Front left front right
Because why not
Reviewed in the United States on February 10, 2025
Functionally you'll have lights but these would only work as tail end lights on our Kawasaki Vulcan and we could never get the bolt tight enough for the light to stay oriented right. Friends started making a game of turning them in different directions because they seriously wouldn't stay straight. The rubber and bolt it came with just didn't hold it well but if you check it often you can make it work or just get some better bolts yourself. It's cheap quality but for the price it gets the job done. Lights up well enough. Easy to install, fits up fine, looks alright. We did have to do a bit of wiring to make these work on 2012 Vulcan we had, it still worked fine but still had to check the bolts occasionally to make sure they were tight as the rubber wore.
Chris Smith
Reviewed in the United States on January 4, 2025
These lights arrived in good condition, however the title was misleading. The description for these lights claimed they could fit a 2011 Kawasaki Vulcan 900, however the end connectors were incorrect for the factory harness and they also use 10 watt bulbs where the factory lights use 21 watt bulbs. As a result of this, the lower current will trick the bike into thinking a bulb is out and will cause the blinkers to blink on the rapid pulse.I was able to solder the factory wiring onto the bulbs, but to fix the issue with the fast blink you have to put a resistor in parallel with the lights (in my case 13 ohms). The resistor also has to be capable of withstanding at least 20-25 watts to be safe or it will burn up. This should have been built into the lights, but for the price I won’t complain too much about this.Also, for the front lights the OEM blinkers use a 3 wire harness while these lights only have two wires. This is an issue because the bike will lose the capability of using the blinkers as running lights unless a normally closed relay, or a pmos transistor, is installed to act as the field or gate contact for the blinkers. Because of this I chose not to install the front blinkers.Overall these are decent blinkers and fit into the bike mechanically, but do not buy these if you are expecting a plug and play solution. These blinkers require some knowledge of circuitry to install and make work like the factory blinkers.
julian
Reviewed in the United States on January 31, 2025
Great deal for the price and quantity. I would definitely recommend. The quality was great for the price and I was glad I found these is the price for four was very exceptional and the quality was really good.
Cassidy
Reviewed in the United States on January 20, 2025
The media could not be loaded.
Marie 🌟
Reviewed in the United States on September 1, 2024
The Turn Signal Lamp Set is an absolute game-changer for my Kawasaki Vulcan! The amber lights are incredibly bright, ensuring maximum visibility on the road—essential for safety. The installation was straightforward, and they fit perfectly on both the front and rear of my bike. The quality is top-notch, and they give my motorcycle a sleek, modern look. If you're a Vulcan rider looking to upgrade your signal lights, this set is a no-brainer. Fantastic value for the price! Highly recommended!
Boo
Reviewed in the United States on August 7, 2024
The original equipment lights tend to break with age, these direct replacements make it easy to switch out the defective ones for this new set.They look great on the bike.
Customer
Reviewed in the United States on August 31, 2024
I had to purchase new bulbs. 3 out of 4 were burned out.
Recommended Products