Your cart is empty.
Your cart is empty.Wheeler's Bore Lapping Compounds are available in three grits: 220, 320, and 600. This combination of lapping grits allows for cutting (220), smoothing (320), and polishing (600) your firearm's bore. The compound is useful for a variety of applications including lapping bores, bolt faces, and bolt lugs. When lapping a bore, pressure will likely increase with grit impregnated bullets. Due to the likely increase of pressure, light loads are recommended. Five shot strings up to a maximum of twenty shots of each grit are recommended. Use progressively finer grits to reach a significantly smoother bore. Each 1 oz jar includes high-quality silicon carbide abrasive paste.
Tim
Reviewed in the United States on September 23, 2024
Works as should.Fast shipping.
Squid
Reviewed in the United States on September 22, 2024
same results after multiple uses. no variation in abrasion or cutting speed.
David K
Reviewed in the United States on February 10, 2024
I do a lot of rifle scope mounting. This product works great lapping in the rings
Upstate NY Guy
Reviewed in the United States on January 10, 2024
Good for lapping scope rings
kzinti
Reviewed in the United States on August 3, 2023
This worked great to allow a Beretta/Benelli choke tube to screw in all the way. Initially, I could only get it to go about ½way, into the lower barrel of an inexpensive Turkish shotgun, although, it would fit the top barrel fine. The piece was purchased over the internet and shipped to my FFL dealer, so I didn't want to go through the hassle of returning it etc. I would recommend also purchasing a real Berreta choke wrench too. I just smeared some of this compound on the threads of the choke tube and screwed it in until it felt tight and then it backed it out and repeated the procedure. On each try, the choke screwed in a little further. It took about 5 (or 6) times and now the choke is fully bottomed out the way it should be in the barrel. It was harder getting the stuff OUT of the threads afterwards than actually chasing the threads. I just used lacquer thinner, with an old toothbrush wiping with "Q-tips and paper towels. I kept it up until the paper towels came out clean.
Robert Tylka
Reviewed in the United States on December 2, 2021
Works very well with Wheeler's kit for lapping scope rings.
John fontaine
Reviewed in the United States on June 24, 2015
Good product
Oodalink
Reviewed in the United States on November 18, 2015
It is exactly what I ordered, however, for some reason Wheeler only fills the container approximately 1/3 full. The size of the container is misleading when you take into account the amount of product you receive.
Recommended Products
