Your cart is empty.
Your cart is empty.Product Description
J J. Wagner
Reviewed in the United States on February 7, 2025
I have not installed a buried ethernet cord outside to set this up in the distance outside but rather have used in include POE box to power it to be a wifi repeater to extend the inside signal to the outside. So far it has been rock solid. I might note that in addition to connecting to my own network, if you happen to have access to one of the Xfinity WiFi Hotspot but only have a good signal in one spot, this was able to connect it so you could use your laptop without fusing with an optimine location to get a workable signal.I do have a quibble with a couple aspect their cable management. The largest is that the opening through the supporting plastic is unnecessarily small. Sure its fit allows indoors ethernet cables through where their strain relief is the same width as the ethernet connector, but premade outside, Direct Burial waterproof ethernets typically have a thicker hood. I had to resort to using an exacto knife to shave out corners in the ring to pass through an outdoor cable. Second, the rubber plug gasket comes with just a hole which would work if you were feeding in just a cable with the connector to be crimped on later. But for a premade cable, you have to use your exacto knife again to make a cut from the outside to the center hole so the rubber plug can be fit over the cable from the side.
🐹
Reviewed in the United States on February 25, 2025
The Wi-Fi extender has two antennas and includes a web interface for setup. I also got an Ethernet cable, a PoE (Power over Ethernet) adapter, and some parts to make the Ethernet connection waterproof, zip ties and a mounting bracketWhen I first set it up, I connected the Wi-Fi extender to my router and entered the device's IP address 192.168.10.1 to access the web interface. In the web interface, I followed the steps of the wizard and was done with it in minutes. The Status page provides me with details like the connection type, number of clients connected, WAN type, Wi-Fi SSID, device IP, gateway, channel, uptime, firmware version, and WAN MAC address.I navigated through various setup options, including network settings, time settings, login password, backup/restore, firmware upgrade, device status, logout, and device reboot. In the network settings, I configured the IP address, subnet mask, gateway, and DNS settings, choosing between static and dynamic IP based on my network requirements. I chose a static IP so I can access the web interface without having to check what IP it's using every time.It has additional settings to customize and secure the device, such as setting the time, changing the login password, and backing up or restoring configurations. In the Backup/Restore settings page, I clicked on backup to save my configurations on a file named RT2880_Settings.dat. I can use this file to restore my settings in case I have to reset it. I can also reboot through the interface.
Our Family
Reviewed in the United States on February 22, 2025
I recently picked up the WAVLINK AC1200 Outdoor WiFi Extender, and overall, I’m pretty impressed with how well it performs. I needed something to extend my WiFi signal across a large outdoor area, and this device has delivered solid coverage with minimal fuss.Setup & InstallationSetting it up was fairly straightforward. It supports multiple modes (Router, AP, Repeater, and Mesh), but I’m using it in Access Point mode. The included Passive POE made it easy to install in a spot where I didn’t have a nearby power outlet. Just one Ethernet cable handles both power and data, which keeps things clean.Tip: The user interface isn’t the most modern or intuitive, but following the included manual gets you through the setup. If you’re tech-savvy, it shouldn’t be an issue, but beginners may need a bit of patience.Performance & RangeThe range is where this extender shines. The 4x7dBi omni-directional antennas push a strong signal across a large area—enough to cover my backyard and even part of my neighbor’s property. Both 2.4GHz and 5GHz bands work reliably, though the 5GHz band naturally has a bit less range but delivers faster speeds. I get a strong, stable connection even 200+ feet away.In Repeater mode, the speed drops a bit (which is normal for repeaters), but in Access Point mode, it consistently delivers speeds close to my main router’s output. It handles multiple devices streaming and browsing without noticeable lag.Durability & WeatherproofingLiving in an area with unpredictable weather, I was concerned about durability. So far, it’s withstood rain, wind, and freezing temps without any performance issues. The IP65-rated weatherproof housing seems tough enough to handle the elements long-term.Pros:Strong, reliable signal with wide coverageFlexible modes (Router, AP, Repeater, Mesh)Easy installation with Passive POEWeatherproof and built for outdoor useCons:Web interface could be more user-friendlySpeed drops slightly in Repeater modeRequires basic networking knowledge for advanced settingsBottom Line:If you’re looking for a durable and reliable outdoor WiFi extender, the WAVLINK AC1200 is a solid choice. It’s not the most plug-and-play option for novices, but it delivers excellent range and performance once set up. Perfect for extending WiFi to large outdoor areas, gardens, or guesthouses.
BobC
Reviewed in the United States on February 22, 2025
I was impressed with this AP. Right out of the box. It booted up in AP mode allowing access into my network with minimal issues. Much better than a previous Wavelink AP that I have.This unit can be used as a stand alone AP, as a router or as a repeater.The interface is clean and fairly easy to navigate.Here is how I rate items:5 Stars = Exceeds all expectations, A definite buy! (Very Rare)4 Stars = Very good find, you should definitely give it a shot.3 Stars = It works and functions as advertised.2 Stars = A little scary, possibly OK, it may work out.1 Stars = Avoid this product, not worth the effort.
Recommended Products
$39.99
$ 18 .99 $18.99