Your cart is empty.
Your cart is empty.The WARN 98348 provides a remote socket extension, allowing you to mount your socket away from the control pack. Kit includes: (1) remote socket extension in black. For use with all WARN truck and SUV winches using 3 or 5-wire control pack configurations; compatible with older round sockets or new D-shaped sockets.
Wiryhog
Reviewed in the United States on October 16, 2024
The media could not be loaded.
Ronald Luckscheider
Reviewed in the United States on October 12, 2024
Mounted in the bumper it would have been beneficial it's a portion that mounted in the bumper was a little bit longer but it did the job.
GMan
Reviewed in the United States on July 10, 2023
Way to expensive for what it is considering the quality.
Bart in Arizona
Reviewed in the United States on July 15, 2022
Terrible design. To mount you must either cut the wire in half and re-splice once you’ve fed it through the mounting hole, or drill a hole so large that you need to add a backing plate or something else to cover the exposed area. I chose to cut and splice. BTW, despite what WARN says, it works with the EVO 10
CrashOnTheIsland
Reviewed in Canada on June 19, 2022
This product is completely incompatible with my Warn Reflex 8000lb winch.
Retired EE
Reviewed in the United States on January 26, 2022
Any reason why a cable cost $100 ? Give me a break. A $10 item.
Customer
Reviewed in the United States on April 1, 2021
Just what I needed
GLOCKer
Reviewed in the United States on August 17, 2020
WARN told me after I ordered this that it wouldn't work with my VR EVO 10S, but I tried it out and it works perfectly. I can't access the socket because of the way my bumper is designed and we had trouble mounting the control box on top of the bumper. I have this run up to an access door in the front of the bumper and I can plug my remote wire in at that location into this socket extension.
That f'n guy
Reviewed in the United States on September 29, 2019
The product works for my vr12 but there's also an issue with it. I drilled a 1 1/8" hole in my truck fender to pass the cord through. The "d" connector wont fit through because of the corners. If you go any bigger with the hole then the socket that gets screwed to the body won't cover the hole. Even a 1 1/8" hole is pushing it. I ended up using a triangle file to cut the corners into the round hole and I used black silicone covering the back of the socket and around the edges to cover where the corner cuts stick out. It doesn't look bad and wasn't much extra work, it just seems like something Warn would have caught before they put this product on the market.
Recommended Products
$170.00
$ 77 .99 $77.99