Your cart is empty.
Your cart is empty.The Virtue Spire CrownSF-R is the budget-friendly speed feed with many of the same design features found in the more expensive CrownSF. The CrownSF-R features the same locking speed feed ring that fits securely in place on the CTRL, Spire IR, IR², Spire III and Spire IV, with the main difference being the design of the fingers. The main difference with the CrownSF-R is each finger is co-molded from two materials and functions without springs. The soft elastomer hinge base allows the SF-R to reload with ease, while a more rigid exoskeleton layer locks each finger into place and minimizes paint from spilling back out of the loader. The five toolless removable fingers allow for easy cleaning and replacement if necessary. A spare finger is included.
DMan
Reviewed in the United States on March 30, 2024
Works as needed.I'm finicky and the center spacing is as large as a paintball so I'm still ocd about paint spilling out.
George Martinez III
Reviewed in the United States on October 8, 2024
Can’t beat this speed feed for the price. Works as good as any other speed feed for half the price.
Kody Standridge
Reviewed in the United States on April 3, 2024
No complaints on my IR2. Can survive the NXL.
Darb Enots
Reviewed in the United States on June 27, 2023
Unlike all the other lids this ones fins are all rubber so nothing to break. The rest use flimsy plastic and even a little spring that so easily break from a fast reload or getting shot in hopper.
G. Thomas
Reviewed in the United States on June 24, 2023
super easy to install and installed in less than a minute...even if you have never done it before. The design was well thought of and integrates perfectly into the hopper. Highly recommend this speed feed for those that want the extra convenience while on the field. Also, it does a great job of making sure the paint stays in the hopper even when completely upside down or your marker falls to the ground.
Alfonso S.
Reviewed in the United States on January 9, 2023
Loved it it works perfect and saves a lot of time I don’t regret it
Customer
Reviewed in the United States on August 28, 2022
Relatively inexpensive. I have an IR2, the mounting tab fits, but when you go to close it, it's a completely different latch. there just isn't any way to get it to latch. Some double sided velcro fixed it in a pinch, but I'm kind of disappointed. Also, if the hopper is full and you tilt 45 degrees, balls can slip out, works better not quite full. Fine for speedball until you slide or the gun goes horizontal? I should have spent the extra $10 and got the other models.
Philly
Reviewed in Canada on August 17, 2022
Bought for my Spire 4 280. Works beautifully, install takes seconds! You even get a spare tooth. I think if they made the teeth bigger that would decrease the center gap, reducing the chance of any paintballs popping out but this is very minimal compared to previous speed feeds I've had. 2 thumbs up!
Erik
Reviewed in the United States on March 28, 2022
Cheapest speed feed you can get but expect to lose some paint while moving, I’d spend the extra 20 and get a metal one that doesn’t let paint out
Recommended Products
