Your cart is empty.
Your cart is empty.RWM V-Groove wheels are high strength cast iron (VI) castings or forged steel (VF) forgings machined with a 90 degree groove for operation on an inverted angle iron track. Care must be made to assure the inverted angle iron track is parallel to ensure smooth and constant tracking. In some cases it may be advisable to run inverted angle iron on one side with V-Groove wheels and flat bar stock steel on the other side with a flat faced cast iron or forged steel wheel. V-Groove Wheels are used to control the flow of a load, i.e., into an oven, between machines, over long distances or where "production line" sequence is required. Bore is available in various sizes on some wheels and Keyways can be installed on most sizes.
K. Fall
Reviewed in the United States on February 5, 2025
Worked as advertised, a quality part. Thank you!
Juan Barriga
Reviewed in the United States on August 19, 2024
It fitted perfectly and it works great. Excellent product!
Ascencion Flores
Reviewed in the United States on December 4, 2024
very good
carlos arturo zurita lopez
Reviewed in the United States on November 3, 2024
Intalled in my pulling post project
Richard Eggert
Reviewed in the United States on November 11, 2024
Barn door rollers
Customer
Reviewed in the United States on October 24, 2024
The media could not be loaded.
AMADO
Reviewed in the United States on August 29, 2022
Bought it to replace worn out wheel of main gate of subdivision.
Rudy Seiler
Reviewed in the United States on March 30, 2013
I'm restoring an old portable sawmill. The wheels are designed to run on the top edge of a piece of 1/4" angle iron. The existing wheels were completely shot and weren't effective to start with. I ordered a set of (4) of these wheels and couldn't be happier. While designed to run on a piece of inverted angle iron, the center grove worked out perfectly for trackiing on the edge of the heavy steel on the frame of the mill..I read one review where the guy was badmouthing these wheels because they weren't sealed bearings. Each of these wheels come with a zert fitting to grease the bearings and I even found some zert axles ($0.99 each) to use with them. I needed a cheap but durable solution to my "industrial" application. I'm very happy with what I found. My advise...if you need a sealed bearing caster....look to spend a little (well....maybe a bit more than a little!) more money and buy what you need.
Recommended Products
$29.95
$ 15 .99 $15.99
$27.42
$ 12 .99 $12.99
$79.95
$ 32 .99 $32.99