Your cart is empty.
Your cart is empty.Vibra-TITE 150 Wicking Adhesive and Sealant is a fast cure, low viscosity anaerobic compound which enables the material to seek voids in assembled components and cure anaerobically (absence of air) on close fitting metal parts. Vibra-TITE 150 can be used as a post assembly application preventing loosening of metal threaded fasteners. Ensure parts are clean, dry and free from oil and grease before use. Product is normally hand applied from the bottle directly onto threaded parts. For porosity or hairline cracks in casting products, brush directly onto the parts. Fixture Speed without Primer is 10 minutes. Shelf Life is 12 months at 68 degree F. 24 hours at 68 degree F Full Cure Time. 20-100 inches/lbs Typical Breakaway Strength. 200-350 inches/lbs Typical Prevailing Strength. Product should be stored in a cool and dry location at temperatures between -10 degree C to 30 degree C. Optimal storage is 22 +/- 4 degree C. Shelf life is 18 months from date of manufacture when stored at 22 +/- 4 degree C. Designed specifically for use on pre-assembled fasteners up to 1/2'' in diamater and porous die castings. Protects welds from rust and corrosion. Hand tools are required for disassembly. 0.004 inches Maximum gap fill. 85/250 lbs Torque strength, Break/Prevail. 1.08 Specific gravity. N or T Suggested primer. 50 ml Bottle.
Joel Murray
Reviewed in the United States on August 7, 2024
I used this during installation of my bullet antenna as a theft deterrent. This will make it more difficult than a quick twist to remove it from my truck.
James Ellis
Reviewed in the United States on October 12, 2024
Yes it works well
dave88
Reviewed in the United States on January 15, 2024
Used this to stop a small leak in a fitting going into a pressure regulator assembled by the manufacturer. I didn't want to disassemble that section of piping. Fantastic that it is sold in 2ml quantities bc i only needed a few drops.Notes:1) it will not form a seal over Teflon tape or wick into areas sealed by tape, it must mate against two clean, non-oily surfaces.2) it will not seal large thread gaps. You'll need to use a non-wicking sealant for that.
First Mate Smee
Reviewed in the United States on December 22, 2021
First time with something new. Worked out great
Bill Buppert
Reviewed in the United States on November 9, 2021
I use these for optics on rifle and pistol and they have yet to fail me. The violence of action on a Glock pistol [any semi-auto mounting a red dot] going into battery and firing doesn't diminish the tight and secure anchoring of optics.Fantastic product.
Adam
Reviewed in the United States on September 24, 2020
I was trying to find a non-permanent thread locker and found this. The wicking action to put it on is so much more convenient than using your typical blue thread locker.
Thomas m vessels
Reviewed in the United States on September 18, 2020
The product did exactly what I expected. I wanted something that would self wick into the threads after the parts were together. Works well. That's why it's so thin !!
Mike
Reviewed in the United States on May 30, 2020
This is some good stuff. High strength and self wicking. Don't put it on anything you need to disassemble later.
Recommended Products
