Your cart is empty.
Your cart is empty.Vibra-TITE 125 Gel Threadlocker is an anaerobic thread locking adhesive for all types of metal, threaded fasteners. Cured performance shows controlled medium strength with good temperature and solvent resistance against water and non-polar solvents. This product cures rapidly on plated, oily metal surfaces or inactive surfaces. Replaces lock washers and plastic inserts. Locks machine tool access bolts, studs, and hydraulic system bolts. Used on gear box bolts/drive shaft, bearing cover cap screws, counter sunk screws, conveyor roller bolts and construction equipment. Ensure parts are clean, dry and free from oil and grease before use. Product is normally hand applied from the bottle onto threaded parts. Fixture Speed with Primer is
James Place
Reviewed in the United States on January 21, 2025
Easy to dispense just the right amount Plus it stays where you put it.
Abraxas
Reviewed in the United States on February 27, 2024
I use this product on pretty much everything these days. It holds well and doesn't require a jackhammer to get things apart. It does not dry up like the traditional tube type stuff. It doesn't run all over the place when you apply it. It costs a little bit more than some. But when I think of how many half used tubes of the liquid type that I threw away due to them being dried up I realize that I'm saving money in the long run.
J Feldman
Reviewed in the United States on October 27, 2024
this product works very well ,as described, and no mess as it is a gel and does not run or drip. Very easy to use but I wish it had come in a smaller size as well. I use very little and not very often, so this size is more for a repair shop than a hobbyist
Baron Von Johan
Reviewed in the United States on June 25, 2023
This is good stuff, it works fine and the pump bottle is quite nice for both application and non spillage and as of this writing I have zero issues or complaints with it and will use up the bottle for sure. Comes out blue and turns kind of purple as it cures. I have not tried to remove it or free a screw I've used it on yet so I left that rating empty, but I expect little to no trouble. I'm using it mostly on rc car screws. Now for my headline. If you read this far I assume you are like me and have used and love Tamiya blue thread lock. The stuff is just THE BEST but it can be hard to get, especially in large quantities. I was hoping that this would be the same stuff but sadly it is not. So if you are looking for Tamiya blue or equivalent, this isn't it. This is thicker and will not flow at all and does not stay semi gummy like Tamiya blue. Also Tamiya blue fans will know what I'm talking about but this stuff doesn't smell nearly as nice either. Hope that info helps someone.
R.L.B.
Reviewed in the United States on February 28, 2023
I've switched over from Loctite to Vibra-TITE.This gel is way more convenient than liquid products because it can be pumped in any amount and stays put. Even after weeks of inactivity, the pump delivers fresh, usable gel. A tiny dab may be applied directly to small screws without any waste; Or a blob to a larger screw.I've never had a screw come loose with this product but when it comes time for disassembly, a little bit of torque is all that's needed.
Alicia Ricciardo
Reviewed in the United States on December 6, 2023
This stuff is incredible. One bottle lasts me about two years. It’s so much easier to use than other loctite and because of the design it’s always pushing it out at Max without leaving air in the bottle. Plus with the cap it doesn’t dry out. It’s all sealed up and it’s the best Loctite I’ve used over all the other brands. I love this stuff!
Customer
Reviewed in Mexico on November 21, 2023
Muy bueno para fijar
Mike
Reviewed in the United States on June 16, 2021
Seriously, this stuff is that good. I literally threw out a bunch of used, half used, barely used tubes and sticks of thread locker that I had lying around after using this product. I don't think it works any better as far as its intended use, but it's so easy to use, no mess, and very minimal waste with the pump gel. I just wasn't going to be bothered with the others anymore. I used it one RC vehicle, primarily on the motor mount screws and the wheel nuts. My main concern was the wheels, because they would still sometimes fly off in the middle of a speed run or bashing session. After a week of heavy use, the only way the wheels come off is if I take them off. I was so happy with the result that I took apart anything that was using thread locker on 3 other cars and applied this to them as well. It's more expensive, but by the time I figured in the amount I wasted of the other similar products I had tried, I honestly believe that this product will save money in the long run, also.
Louie
Reviewed in the United States on February 3, 2020
The pump will stop working once you use up more than 2/3rds of the bottle. I cut open mine so I could reach the large pool of thread-locker at the bottom. It'd be more efficient if this came in a toothpaste bottle design.Still, the product works as advertised. Removable, as long as you don't slather the threads with this stuff. For metal threads, just put a dab on and, with some adequate torque, it is more than enough to keep that bolt/screw/nut on. Good product, but I'll look for different packaging next time.
Recommended Products
