Your cart is empty.
Your cart is empty. Specifications
Platen size: 21.7*17.7" (55*45cm)
Arm Length: 13.25" inches
Arm Width: 10" inches
T-shirt board: 18" x 21.5" inches
Max Screen thickness: 2" inches
Machine size: 32*7.9*55" (82*20*140cm)
The material of the Machine: Steel Plate
Surface Treatment of the Machine: Electrostatic Spraying
Package Content
1 x Screen Printing Kit (Including a full set of brackets, excluding silkscreen frame)
Lance
Reviewed in the United States on September 28, 2024
Needs modifications but works
marvelous art
Reviewed in the United States on July 15, 2024
Had extra parts good thing I knew how to check everything
Mark
Reviewed in the United States on June 17, 2024
I Want to make my own logo shirts going the cheapest possible way with out sacrificing time ,comfort , and some what precision, instead of making homemade caveman crude devices
Tracey
Reviewed in the United States on October 30, 2023
I had no problems with assembling this product. For those saying the surface isn't flat, they did not put it together properly. If you screw the top on lopsided, it is not going to have a flat surface when the arm comes down. Take your time and don't rush the process. This is perfect and works great for my screen-printing needs.
RMJ
Reviewed in the United States on August 18, 2022
It’s a good product, my first press , it’s heavy and sturdy BUuuuuuut it did have screws missing and comes with no instructions!! Just use the Amazon video and watch it over and over .
Scott Trost
Reviewed in the United States on February 20, 2022
The instructions were less then useless, with the second page printed in inverse and only half printed.Adjustable translates to "the tolerences are so loose, you can move it whereever you want". The platen is so counterbalanced it will tip the machine over on its own.The only sturdy part it the t-handle wrench that comes in the kit, which is good because "adjustment" involves constant use of the tool to find some sort of workable setup.If you want to print unique t-shirts, you are in luck as no two imprints will come out the same. On the other hand, if you are looking for consistency, not so much.I would say that you get what you pay for but even then this product isn't worth the time it took to assemble it.
hayden718
Reviewed in the United States on October 17, 2022
The directions, honestly throw them away. This is a self explanatory put together. Grab yourself some real tools to make your life easier and it will take 1 person 30 minutes or less to put together.Once you have it together do not tighten it until you get your center measurement and measurement on where you want the board out to. Once you find your center tighten the under bolts on the sides then tighten the bottom ones. Snug everything. You won’t be about to adjust your springs fully until you have a fully loaded screen on it.Easy put together and exactly what I need for my small space
Ismail
Reviewed in the United Arab Emirates on October 16, 2022
لم اتوقع يكون ممتاز بهذه الدرجة
Ray Toro
Reviewed in the United States on September 11, 2021
Welds are solid, but misaligned; will not be able to just “put it together and start printing”...does require effort to get parts as close to level or alignment as possible....may have to drill a hole or two and pull out a ruler to get it aligned right..The platen bracket is junk. I built one from MDF that fit a lot better and more able to keep platen aligned and from moving during printing. This also helped raise the platen for better printing adjustmentsHad to add shims to the screen holder to have screen level with the platen..Good basic parts kit though; you basically get what you pay for.
Recommended Products
$119.99
$ 52 .99 $52.99