Your cart is empty.
Your cart is empty.Christine
Reviewed in the United States on June 6, 2024
Somehow the limit switch on my CO2 laser was knocked off and damaged. This was inexpensive and the same switch that was on my laser. Replacing the damaged switch could have been a pain but I did not rout the wire through the drag chain. I cut the damaged limit switch off right at the switch and just use Wago connectors to connect the new switch to the old wire. Done in about 15 minutes and it has worked flawlessly. And a bonus, if the switch gets damaged I can just open the Wago connector and connect the new switch. I would order again but hope to not have to.
Shaw
Reviewed in Canada on September 12, 2023
Sensor broke on my 80w chinese laser. Product arrived quickly, was an exact replacement and works well.
Jen Howard
Reviewed in the United States on February 18, 2023
Got what I needed. It worked as it should. Had in and had my problem fixed in maybe ten minutes.
Jason Barnard
Reviewed in the United States on June 14, 2022
I previously had a PL-08N inductive probe, but it eventually burned out. I ordered this one "thinking" if it was a little closer to the printer bed plate it might be a tad more accurate. I guess I never really thought about how close this would put the probe to the bed plate. At first my nozzle was smacking the bed plate before it would detect. I had to adjust the probe down to the point that it was almost touching the print. It works as advertised and I really can't complain about the product itself. But I would highly recommend you go with the 08n (8mm) vs the 05n (5mm). Just a thought.
Michael R.
Reviewed in the United States on February 16, 2022
replaced a tronxy pl-08n sensor. Now I get a great first layer every time. on spring steel heated bed at 110c in an enclosure with the hotend at 240.
John Abedejos
Reviewed in the United Kingdom on October 24, 2022
Ordered this after the probe from my voron kit just died after a few days. Had this for over a month and still runs well.
Steve Masuch
Reviewed in the United States on April 6, 2022
Used on 100w 600x900 Chinese CO2 laser Z axis limit+
Luis
Reviewed in the United States on September 12, 2021
Best
Transamland
Reviewed in the United States on March 7, 2020
Just what my laser engraver needed
Ken Scales
Reviewed in the United States on October 19, 2020
Excellent
Recommended Products