Your cart is empty.
Your cart is empty.Product Description
Features
These Knurled Insert Nut can be widely used on the injection for tightly fixing.
Can be installed by ultrasonic or heat into the plastic matrix, or formed during the injection.
Due to the embossing process on the outer diameter of the insert, it forms certain friction and bites force with the brass insert after forming, which can be fixed on the inside so that it cannot fall off. Has a certain torsion and tension.
Benjamin Mergen
Reviewed in the United States on January 31, 2025
Not sure how you could knock these in any way. Matches description 100%. If you've never worked with these, they're great. Very satisfying to install. If you have a problem with these, you're likely doing something wrong.
MidLifeHiker
Reviewed in the United States on January 11, 2025
I use Uxcell brass inserts for all my 3d printed projects with more than one part. These inserts work very well and are easy to insert with a soldering. I do recommend getting a soldering iron brass adapter to use when inserting. These inserts take your 3D printed projects up another level. I know there are cheaper inserts, but these work so well, I'm not going to waste my time looking for an alternative.
Ryan S.
Reviewed in the United States on September 16, 2024
Needed to make a new frame for my AnyCubic resin printer because they discontinued the product and the 3 party replacements are overpriced, or wrong size entirely. These are quality, no burs, clean threads and most importantly the correct size.
Ken
Reviewed in the United States on August 8, 2024
I nearly replaced the entire vat because resin had worked its way into the threads of the screws and hardened - making it impossible to remove the screws without an extractor. Needless to say some of the anchors had to be replaced afterward. I used a soldering iron to carefully heat the old anchors and then pried them out - then used the iron to push these in. These are seemingly an exact match for the anchors that were already installed in the tank, so they worked perfectly.
Matt Lee
Reviewed in the United States on May 30, 2024
Great price with quick delivery.
Joseph Machnak
Reviewed in the United States on November 25, 2024
Perfect.
Jim
Reviewed in Canada on October 10, 2024
These work well as basin/sink anchors when epoxied into the underside of a counter top.
Phil Tuttle
Reviewed in the United States on April 30, 2024
This was my first order of the threaded inserts and the quality is fantastic. Will likely need inserts in the future and will order again.
Wrong size
Reviewed in the United States on April 29, 2024
they don't twist out or pull out, so long as you don't over tighten them you can pull on it with 100 lbs
Valadas
Reviewed in Canada on September 11, 2023
None of them was mishaped like some others I received. Good quality, precise threads.
Kim Campbell
Reviewed in Canada on August 8, 2023
Not much to say about them, they're accurately threaded, and are exactly as described
Alan
Reviewed in Canada on July 25, 2023
Work well. Would recommend.
benoit
Reviewed in Canada on November 20, 2023
Tiens solidement lorsque bien inserer dans le PLA ou le PETG et Autres
Recommended Products