Your cart is empty.
Your cart is empty.Features: 3/8 inch cutting diameter, 4 flutes, coarse teeth, 3/8 inch straight shank, deep helical groove.Used widely in the milling machines or machine tools for milling the steps, recesses, vertical plane surfaces, etc..
Joe the wood worker
Reviewed in the United States on March 27, 2024
Good end mills at a decent price. They cut well and leave a nice clean finish. I’m very pleased with them.
Claus G
Reviewed in the United States on June 30, 2019
Good product and price for 3/8" finger endmills. Center cutting with no problems. We use it mainly for aluminum milling and it performs great. No unusual runout detected. Good fit in milling machine arbor, no rework required. Comes in small two piece plastic container with size labeling to protect endmill.
Michael Muir
Reviewed in the United States on December 13, 2019
Good product but clogs quicker than just a normal flute bit
JAY E.
Reviewed in the United States on September 23, 2018
Very good quality, cut great
rabitt
Reviewed in the United States on September 25, 2016
needed for project worked well holding up well.
chris knaak
Reviewed in the United States on February 9, 2016
I am happy with my order
Ken
Reviewed in the United States on November 21, 2016
good mill for the money but they are not bottom cutting
Night Hawk
Reviewed in the United States on October 31, 2016
Was used for about two hours in medium grade aluminum. Then it snapped in half. Wasn't on a bind or anything.
Recommended Products
