Your cart is empty.
Your cart is empty. Specification:
Drawn Cup Material: ST14 Steel
Needle Roller Material: Chromium Steel (GCr15)
Bore Diameter (Fw): 8mm
Outside Diameter (D): 14mm
Width: 12mm
Torque: 5N*m
Rotating Shaft Limiting Speed: 16000rpm
Rotating Outer Ring Limiting Speed: 12000rpm
Package Content:
2 x Needle Roller Bearing
Description:
1. Drawn Cup Needle Roller Bearing features a deep drawn, thin-walled outer ring. They are compact bearings with high load carrying capacity and stiffness.
2. These bearings are especially suitable for high dynamic loads or radial-limited installation. They are mounted with a tight interference fit in the housing.
3. Shoulders or snap rings are not required to locate the bearing axially, thus enables a simple and economic design of the housing bore.
Memory Castillo
Reviewed in the United States on July 25, 2023
Perfect size for my ocedar mop bucket
Pedro Martinez
Reviewed in the United States on February 27, 2023
Trabajo como lo indican las sugerencias....
K. patton
Reviewed in the United States on July 25, 2022
Watch a YouTube video tutorial and purchase this part. Not hard to do. Fixed it myself.This part is what I needed
SGS
Reviewed in the United States on July 17, 2022
No complaints
Rose
Reviewed in the United States on May 17, 2022
I Bought the bearing, because my mop bucket was no longer working. I replaced this little part and it worked like new again. Hope it lasts, fingers crossed. ☺️
Tyler Houston
Reviewed in the United States on August 9, 2021
I used this to fix my O'Cedar spin mop bucket. I watched a YouTube video and it mentioned these bearings. They fit perfectly and it's back working.
Laura
Reviewed in the United States on August 3, 2021
I thought I needed to buy a new spin mop but this did the trick.
Alex
Reviewed in the United States on February 15, 2021
Did what they were suppose to do mop bucket now works fine Fast delivery
Recommended Products
