Your cart is empty.
Your cart is empty.Product Description
Product Information
- The product exists warpage deformation, but the product will not have any impact on the use. It is not recommended to be used for work environments with high requirements for coaxiality.
- If the length of product is 25mm, there is 0.25mm of warpage deformation; when the length of the product is 200mm, the product exists 2mm warpage deformation. Note: Product specifications below 10mm in diameter (inclusive) are applicable. Warpage check method: three-jaw chuck clamping, check the runout of the other end, the specific check value as described above.
- High Speed Steel (HSS) is also known as air hardening steel or steel. It is an alloy steel of complex components, including tungsten, molybdenum, chrome, vanadium, cobalt carbide forming elements. Amount of alloying element is approximately up to 10-25%. Under high temperature of about 500℃, High Speed Steel still can keep high hardness of 50HRC above. Red Hardness is the main features of High Speed Steel.
High-speed Steel Tool
High-speed steel rods are with combination of hardness and toughness for wear resistance, high temperature resistance, high-speed performance.
Alain Robichaud
Reviewed in Canada on September 22, 2024
this part is between 50-100micron too small, and it varies along the length. No big deal as i clamp onto it, but still not precise
Jm
Reviewed in the United States on May 9, 2024
Fits inside of suppressor but not barrel
Matthew Petricone
Reviewed in the United States on May 25, 2024
It fit right where I expected it to go. Using it to reinforce a printed ukulele neck.
Dane Cotton
Reviewed in the United States on February 1, 2024
Item is so bent that it won't roll across a flat surface. Don't recommend.
dav67vip
Reviewed in the United States on December 8, 2024
received in good order
Wayne Love
Reviewed in the United States on December 27, 2024
This is a well made steel rod. I used it to repair the top section of a Christmas Tree that had bent and broken the hollow metal tubing. It worked great and being a solid rod, I don't have to worry about that section of the tree bending anymore.
Jordan B
Reviewed in the United States on December 29, 2023
Perfect.
MedicalCheeze
Reviewed in the United States on December 23, 2023
Does not fit the crown of some barrels for psh psh alignment reasons. It's a 9mm rod, straight as could be and the machining is good.
Scott Asay
Reviewed in the United States on May 4, 2021
Maybe I'm crazy, but I bought this as a poor man's muzzle flash alignment rod for a 10/22 rifle. (The "official" aligners can run like 60 or 70 bucks...) It did the job great for my purposes, fitting down the barrel really nicely. It was easy enough to slide in, but yet snug enough that it didn't wobble at all. One caveat is yes, these can have a millimeter or so of warp distributed over the length of the rod, meaning I could only push it in about 80 percent of the way before it started to make light contact with my rifling. But that was deeper than I needed it to go anyway. Inserting the rod about halfway and then rolling it gently through my fingers gives me a VERY GOOD idea of where my bore/muzzleflash alignment is sitting. If any of this sounds reasonable to you, it might be worth saving yourself 60 bucks to give this a try.
Customer
Reviewed in Canada on December 18, 2021
Worked great for me. Used to replace a bent shaft on a model airplane motor.
Recommended Products