Your cart is empty.
Your cart is empty.
Universal Oscilloscope Probe 10:1 and 1:1 Switchable Bandwidth200MHz,Usable with Scopes having Bandwidth up to 200 MHz
Interchangeable Probe Tip.High Sensitivity, Excellent Performance and Reliable Function
Fully-Shielded Welded BNC Connector, Small Signal Interference; Pure Copper Plated Gold Pin for Good Contact Test Versatility and Capability.
1 x BNC to double-headed alligator clip test line; 1 x BNC to double-head test hook test line; 1 x BNC to double-stack test line; 1 x Double-headed BNC coaxial line.
Used with Oscilloscopes from All Manufacturers , Equipped with The Standard BNC Connector.
Randy G.
Reviewed in the United States on February 19, 2024
Very fast shipping.
Alexis Benini
Reviewed in the United States on October 21, 2024
Work well. They come with additional accesories. Just remember to compensate them using the reference signal on your scope (and make sure that the probe is set to 1X when you do that).
Donald E. Titkemeier
Reviewed in the United States on January 15, 2024
Inexpensive and it shows, but, will do in a pinch.
Paul B
Reviewed in the United States on May 26, 2023
This kit has all the extras and will meet almost all of your needs. Great investment.
James
Reviewed in the United States on December 12, 2023
Delivered on time and in great condition.
tjmat
Reviewed in the United States on November 30, 2023
You never have to many scope probes. These are quality probes.
Customer
Reviewed in the United States on November 24, 2022
An economic choice for replacement probes
RobotChris
Reviewed in the United States on September 19, 2021
This may be sufficient for lower frequencies however it does not support what it is advertised as. The first and second image consist of four channels: channel 1 and 2 are using rigols pvp3150, channels 3 and 4 are the probes from this kit.The frequency displayed is only 333Hz which is 1/600th the suggested frequency of 200MHz. Based on the attached images it would seem that at 333Hz has a settling time or about 375 uSec which would make any signal above about 2700Hz nothing but settling time. Again while this may work for other applications and maybe there is some additional setting that I am missing. Regardless, I was looking for frequencies above 5Khz and do not believe the device will settle in time to provide signal values that I can rely on.The third fourth and fifth images show the result of using the rigol DS1054z built in function generator at 1KHz.the third image illustrates that the rigol is not able to capture the waveform properly with just the kits probe at 1KHzthe fourth image illustrates the display when run/stop is selected for the kit provided probethe fifth image illustrates the rigol probe causing the proper capture of the inputs of the 1KHz square waveAdditionally at 1KHz the settle time appears to consume about half the period.I hope this is helpful to someone.
Recommended Products
$12.99
$ 6 .99 $6.99