Shopping Cart

Your cart is empty.

Your cart is empty.

ubld.it™ - MIDI 2.0 Breakout Board MV (Multi Voltage) 3.5mm TRRS

4.4 (2) Write Review
Free shipping on orders over $29.99

$14.99

$ 7 .99 $7.99

In Stock

About this item

  • Arduino Compatible (example sketches available)
  • MIDI IN and MIDI OUT (3.5mm TRS Connector)
  • 5V or 3.3V operation 6n137
  • Optically Isolated MIDI Input (4 Pin Header)
  • This is a fully assemble PCB


The MIDI 2.0 Breakout Board MV board is an easy way to connect a hardware MIDI device to an Arduino, microcontroller, or embedded computer such as the Beagle Bone or RaspberryPi. This version of the MIDI BoB is a fully assemble board. The PCB provides an optically isolated MIDI I/O (Input and Output) signal and power. There are mounting also holes in the PCB for a more permanent installation. An example Arduino sketch is available on the manufacturers website which will get you up and running quickly. MIDI Breakout MV is similar to the old EZ. However, the MV includes a switch allowing you to select 5V or 3.3V levels.


Bryan
Reviewed in the United States on August 28, 2024
When this item was shipped to me, it was shipped with four of the pins sticking through its envelope, meaning it is likely damaged. I bought it as a gift so I can't know for sure, but this is definitely upsetting to see.
JH
Reviewed in the United States on October 6, 2023
It works perfectly and is really convenient. I like the switch for 3.3V or 5V. I use it for prototyping with Arduino, esp32, and RPi controllers. It would be cool to be able to buy these in bulk.