Shopping Cart

Your cart is empty.

Your cart is empty.

TYC 630920 Honda Replacement Condenser Cooling Fan Motor

Free shipping on orders over $29.99

$38.08

$ 17 .99 $17.99

In Stock

About this item

  • OE-comparable, perfectly balanced unit ensures ease of installation
  • All components are new, not refurbished
  • All units are test-fitted onto the corresponding radiators prior to release to ensure precise, consistent fit
  • Legal compliance through patent license agreements with Bosch/Continental VDO (where applicable) for turbine-like blade and shroud designs, providing an additional level of confidence and protection


TYC 630920 Honda Replacement Condenser Cooling Fan Motor


Stephen B.
Reviewed in the United States on September 26, 2023
Have apart can’t use
dkolar
Reviewed in the United States on August 23, 2023
I interchanged to this fan motor from my Kubota rtv1140cpx Mitsubishi fan motor for a third of the price, had to cut motor plug end off an swap them was the only problem I had.
R.H.
Reviewed in the United States on January 4, 2022
Direct bolt in to the RTV1140CPX stock fan shroud.The connector is not the same, but the old one can be spliced onto the new fan. Wires are the same color, Blue and Black. Will need to rotate the motor to align screws, the tabs are not evenly spaced.
Neopheus
Reviewed in the United States on July 5, 2020
It was a perfect fit for the condenser fan in my 2001 Acura MDX. The base is offset, so make sure to rotate until the holes align properly.
J. Furedy
Reviewed in the United States on September 12, 2019
This was a super simple bolt-on replacement/install. The wiring was just a little bit longer than necessary, but better too long than too short. I was able to tuck the excess wire length under the metal cover that bolts onto the back side of the motor. The motor is "indexed," so it will only go on in one orientation. (The three holes are not evenly spaced, so if they don't line up, just rotate the motor until they do.) The electrical plug connected to both the existing wiring harness and to the metal support clip just fine. And the fan blade assembly bolted on just fine as well. Just make sure that you index the fan blade to line up with the flat on the motor shaft. All in all, an inexpensive, but still compatible, replacement for the OEM motor.
Loan Lu
Reviewed in the United States on July 7, 2019
It took me 30 minutes to remove a condenser fan, and another 10 minutes to replace the motor fan. It fits and runs perfectly, but the cost is much less than an OEM condenser fan motor. I don't know how long it will last. My car is 16 years old and about 170K miles on it. I will buy another car sometime soon.
Tim Schoenheide
Reviewed in the United States on September 15, 2016
Was suppose to be a fit for a 2004 Acura MDX, which it is not without drilling new holes into your support. It doesn't line up. Wish these company's would get the information on the parts right. Guess I will go down the road to Advance Auto and pay a few bucks more next time.
Paul
Reviewed in the United States on December 10, 2015
Because of the low price, I was a bit worried about the outcome of installing it. But, the part worked perfectly from the moment I plugged it in and has functioned as advertised through hot and cool seasons. A simple fix for what seemed like a worrisome problem.
Recommended Products