Your cart is empty.
Your cart is empty.TacMasteR
Reviewed in the United States on January 24, 2025
The screws are really poor quality. They stipped after the first use. They work, but get different screws. Quick install if you havent built your kit yet.
getCheeky
Reviewed in the United States on August 1, 2024
This servo holder comes carded. I noticed right away that there's a couple nicks or chips in the corners. This didn't come with any kind of wrap to protect it, so I'm not sure if it's from the factory or from shipping. The stock one has a hole in the top, not sure what it's for, but it's not in this one. Overall, it's fine, if it's a deal I can recommend.
J. A. Maynor
Reviewed in the United States on July 10, 2024
Usually, generic blue add-ons have a weird tint to them, these' were pretty darn close to the tamiya blue on my build. Worked like a charm.
Michael
Reviewed in the United States on June 23, 2024
Pretty decent replacement over the stock. Main selling point is its aluminum.However, it is missing some holes that the plastic stock mount has. Most noticeable is the top hole while looking down at it.I used this hole to mount the antenna wore holder. However, there is not hole on this aluminum block.
Scott
Reviewed in the United States on May 28, 2024
I'm building a Tamiya TT-02 from a kit. It comes with some of the basics but with no Servo Mount. This one fits perfectly and is manufactured very well. It comes with the hardware needed, which is minimal. There is really not much to say, it does exactly what it is supposed to do.
Rob T.
Reviewed in the United States on May 27, 2024
This servo holder was an easy bolt-on upgrade that upgrades the steering. Before the servo was shifting and flexing when steering even on the work lift. This may still allow a small amount of flex but much less than the stock plastic pieces that have no cross bracing.
Shannon L. Plesh
Reviewed in the United States on May 24, 2024
I installed this aluminum servo mount on my TT-02 chassis. I used all the included hardware, and everything fit perfectly. It only took me about 15 minutes to swap everything over. This mount is more durable than the standard plastic mounts, and I like that it gives me a place to put my receiver on top.
Ezveedub
Reviewed in the United States on May 23, 2024
Mount comes with stainless steel screws. Hex head 2mm flat head and button head with washers, not Phillips head like OEM Tamiya. The anodizing is good, but not perfect like Tamiya, but works and doesn't affect its purpose at all. Mount was installed just like it should with blue thread locker applied to bolts for securing them from coming loose. Overall lower cost to Tamiya original, with same performance.
Recommended Products
