Your cart is empty.
Your cart is empty.The 47 Series are the industry's only metal break-to-fit narrow refills. The stainless steel rails are scored at 1-inch intervals from 15-inch through 26-inch to make customization a snap.
Shelly
Reviewed in the United States on September 3, 2024
I have ordered both the 47-600 and the 47-700 in the past and they have worked well for my 2 vehicles. This time I ordered both sizes again and the 47-700 that arrived is the exact same width as the 47-600 which didn’t work for the car this size previously worked on. I thought maybe there was a packaging error made by someone who returned a set so I ordered another 47-700 and once again it is the same size as the 47-600. Either there is a manufacturing change or a packaging error but if you are looking for 47-700 be aware that these might not fit. I ended up keeping the sets I purchased for the vehicle that uses the 47-600. The quality is fine but the size of the 47-600 is wrong.
Lance
Reviewed in the United States on November 12, 2023
These fit in the arms fine but the locking hooks are too small for the OEM wipers. This means they won’t lock in place and will come out under normal use, possibly scratching your windshield. Since MINI’s are made by BMW I would expect the same problem on Beemer’s.
Charles Seymour
Reviewed in the United States on April 20, 2021
PERFECT fit for 2002 Maserati Cambiocorsa. NAPA listed a pair as correct for the car and they ALMOST fit (Grrrrr) but they were 6MM, these are 7MM which makes all the difference in the world. This car has super special AERO items on the wipers so they'll work at 176MPH. Using these refills allows you to keep the stock wipers WITH the special (3) Aero items attached. Install per directions leaving the clips on as you slide the refill in. The clips slide down as you push&pull the refill through.
Customer
Reviewed in Canada on September 29, 2020
I liked this product because it fit my car just right.
Customer
Reviewed in Canada on December 15, 2020
Buyer beware! Too bad this economical repair is so hard to get right!There were no Anco refills available here at purchase time. I had looked a lot elsewhere before settling on these!Also checking both Amazon's and other dealers car match info; which ok'd the fit of these Trico refills for my vehicle make and year.As correctly stated; the Trico 47-700 assembly with metal rails is 7mm wide. But upon attempting the installation; I found that an 8 mm assembled width was actually required. This would fit properly into the trapesoidal claws on the wiper frames.So then; when attempting to just use the rubber part of the refill; the mounting spline on the back of the refill proved much too wide to slide into my factory wiper arm frames!Not entirely Amazon's fault here. But in future I would prefer to see cross section illustrations of any Trico rubber refills sold. WITH measurements!! ........ WHY NOT??( Attempted to enclosed 2 easily found Anco examples, but they were not allowed due to copyright. )
Hoss
Reviewed in Canada on January 9, 2020
Just got around to installing them on my 2011 Infiniti M37. They did not fit. Too short. Should not be listed to fit this car. Money lost.
Customer
Reviewed in Canada on February 24, 2019
good deal but don't fit on my wiper frame
kevin tytula
Reviewed in Canada on July 15, 2016
Terrible lasted one sweep of the wiper
J. Foster
Reviewed in the United States on November 2, 2016
This is very good quality and VERY easy to install. However, I have my 2016 Mazda CX-5 in Amazon garage and these were listed to fit the right side wiper. This would apply to the 2012-16 CX-5. This was way too small for the wiper, the 8 mm (listed for the left side) is the proper wiper refill for this car on BOTH sides. You will see a clip side with 2 metal prongs on either side of the refill, when you insert the first slides easy and then the prong facing toward pushing it in will need to be pressed in with pliers to install all the way. When you are done a flat head screw driver can be used to pry the prong back out to clip the wiper refill in place.
Midnight Distortions
Reviewed in the United States on June 12, 2015
Great buy, so much that i might buy a second pair as the first pair fits both of my wiper blades easily. It is a bit hard to get them on, i had to bend part of my wiper blade so i can fit in this insert (plus to get the old one out). The biggest benefit here is the fact it would cost me $16.99 + tax just to get one blade side so this is definitely a deal and it would be nice if auto part stores carry and considering the rubber wears out after a year or two (i actually had to glue the older ones back together since they were ripping apart) but these winters are pretty harsh so these new sets i will primarily use during the warmer seasons where they should last longer but will switch back to my MacGyver fix'd wiper blades when snow/cold weather hits, but will buy an extra set here just in case those MacGyver blades no longer work sufficiently. These are a great buy if you got a set that fits. I have yet to try them out on my vehicle but they look like they would work just great. These will work for a 2000 Pontiac Grand Am if anyone is wondering, but may fit other cars as well. I just don't want to spend money on a part that i do not need, i do not need the metal bracket that this thing goes on to so it's just a waste of money and resources. I can kinda understand sometimes you want an easy fix, just replace your blades with a new set and you are good to go, it took me 5 minutes to put on one blade on but in these days 5 minutes of my life just saved me $16.99. I wouldn't do it any other way for now, while these still are available i will continue buying these!
CL
Reviewed in the United States on February 21, 2014
So far these refills are cleaning well with no streaks and no squeaks. For years I used Anco refills (which are a little easier to install due to their one-piece design, without the separate metal strips) but they were no longer sold at any local stores. I tried replacing the entire blade with an Anco product but the squeaking drove me crazy. Luckily, I saved the original factory blade assemblies, which still work well after 10+ years. I have a 2003 Mazda 6, and these 7mm Trico refills fit just right. The Amazon fitment guide said that the 6mm, 7mm, or 8mm sizes would each fit but I think the 8mm would have been too large. My blades have a square claw shape, but the trapezoidal cross section of these refills fit just fine. Another bonus is the "break to fit" feature. My car has an 18" long wiper blade on one side and a 22" blade on the other. With one package I was able to easily fit both wiper blades.
illusion buster
Reviewed in the United States on October 20, 2013
Even though rated for my car they don't fit even if they did fit they seem like they would be pretty hard to get into the slots. It is not worth the frustration of dealing with these you can buy Valucraft Wiper Blades for 6 or 7 dollars each at your local auto store, it is the complete wiper blade not just a refill, it easily snaps in place in seconds.The Amazon seller I purchased these loser Trico refills from is "Titan Direct" , they ship them in a thin plastic bag and they arrived badly bent. I was able to straighten them out but they still did not fit.The seller "Titan Direct" tried making excuses when I complained to them asking me for proof by taking photos and making me go through a monkey act for them. I complained to Amazon about them and left them steaming feedback they quickly refunded me and the feedback was automatically removed by Amazon. "Titan Direct" has a poor 88% rating which should be even lower since they are now resorting to giving money back to get the negative feedback erased.
Love Wireless
Reviewed in the United States on October 2, 2012
I always thought changing the entire wiper is such a waste but never knew how to change just the rubber part. bought this to give it a shot and it works great and not much harder than changing the entire wiper.One lesson I learned is to measure my own wiper "holder" width first. I had a little problem with the width of the metal strips. I realized that the rubber part is about the same as the old one so I recycled my old metal strips and it worked like a charm. Really it's pretty easy and now I'm saving money every time.
Recommended Products