Automotive Sound Heat Insulation Mat- in a cost-effective manner

An overall more comfortable environment are what you can expect when you start sound proofing your car

• Sources of Vehicle Noise :
• 1. Engine noise: The vehicle engine is a source of noise, and its noise generation varies with the engine speed (mainly through: front fender, hood, fire wall, exhaust pipe generation and transmission).

• 2. Road noise: Road noise is caused by the wind cutting in and driving the chassis vibration when the vehicle is driving at high speed. (mainly through: four The door, trunk, front fender, front wheel arc generation and transmission).

• 3. Tire noise: Tire noise is caused by friction between the tires and the road surface when the vehicle is driving at high speed. (mainly through: four doors, trunk, front fender, front wheel arc generation and transmission).

• 4. Wind noise: Wind noise refers to the pressure of the oncoming wind that has exceeded the sealing resistance of the door and enters the car during high-speed driving. (mainly through: four The door seal gap, including the production and transmission of the whole thin steel plate).

• 5. Resonance noise and others: The car body itself is like a box, and the sound itself has the nature of refraction and overlap. When the sound is introduced into the car, if there is no sound absorption and sound insulation material to absorb and block, the noise will be Continuous refraction and overlap, the formation of resonance (mainly through: noise enters the car, superposition, reflection).

Installation suggestions:

Car heat insulation mat is used in many applications, such as muscle cars, hot rods, light cruisers, imports, tuners, street rods, mouse rods, classic cars, racing cars, stock cars, old antique cars, pickups, trucks, low rider and many more. We even have customers using it on their SUV, vans, RVs, luxury cars, campers, yachts, RVs and school buses.

installation steps

Step 1

Remove the part of your car where you want to install the heat insulation mat, based on the instruction to your car on the internet and read carefully as to how to dismantle a certain panel.

Step 2

According to the effect you want choose construction program , you had better make a pattern of in appropriate size on the paper and then cut down the right size of mat for the panel . Never install and then cut with knife , it is likely to damage the panel . The best advice is to crop the size you want and install it into the appropriate section.

Step 3

Install the screws back in original place , it will easy be found when you mount , avoiding holes be covered.

Note: this cannot be directly used to cover the exhaust pipe. It can be used in the firewall or under the vehicle to reduce the heat penetration of the exhaust system

1.Not to be applied directly to heat source including: exhaust pipes, mufflers or hot turbo pipes

2.As different computers display colors differently, the color of the actual item may vary slightly from the above images.

3.Please allow 1-2mm thickness differs due to manual measurement.

4.The image shown here is indicative only. If there is inconsistency between the image and the actual product, the actual product shall govern.

5.Length and Width : 39" wide , is sold by the LENGTH and cut to order,

For example , order of 1 ( Qty = 1 ) is 39" x 60" . Order of 2( Qty = 2 ) is 39" x 120 " one continuous uncut piece.