Your cart is empty.
Your cart is empty.Alexis
Reviewed in Belgium on July 28, 2024
Ce produit est top !Il se découpe facilement, adhère très bien et remplit bien sa fonction d’isolation.Je le recommande.
Sergii Buth
Reviewed in the United States on July 22, 2024
Used this one as sound deadening in the trunk and as a padding material for engine cover. Was a bit afraid when using right above the engine, but it performs really well - stick adhered as initially, still soft and spongy. It s a good choice item.
Peter Shepherd
Reviewed in Germany on March 22, 2023
Took a while to arrive but it does what it's supposed to do.
Moon Dog
Reviewed in the United States on November 16, 2023
This stuff is good for the money but only if you are willing to put up with a couple things. It really does great noise reduction but it is not properly packed and shipped and it really makes it just OK where it could be great. It comes folded instead of rolled and has a lot of creases. This causes the backing paper to come off while it is sitting around or shipping and messes up the adhesive which is just OK. I've used many of these products and this is by far the cheapest but I had to use some spray adhesive in a few spots because the adhesive was just gone on the foam. Also it will never un-crease from the folding, I tried sun, hair dryer, letting is sit for a week, so it will never look very good even for black foam. So if it is going somewhere your don't need perfect adhesion and you never have to look at it, it's a good deal.
Amare
Reviewed in the United States on January 24, 2023
I really dont understand why people are complaining about this product. Its fantastic. Yes, it comes folded, which is less preffered to rolled up, but the paper does peel fine as long as you are slow and careful. Ive worked with far worse materials where no matter how careful you were the paper would tear. The foam is super easy to cut, you can even tear it with your hands, however i recommend using an xacto knife and scissors. Im using it alongside some new speakers i got for my 2016 Toyota Avalon which has some unbearable rattling sounds when listening to music. This product helped eliminate 90% of the rattles.
Alan Garner
Reviewed in the United States on December 31, 2022
I have a Jeep wrangler that I recently put a new exhaust on which caused the exhaust sound to increase. Jeeps are not exactly quiet; however, the new exhaust system made it hard to have a conversation inside at highway speeds. Also, the exhaust used a larger pipe (which runs under the left side floorboards) and there was more heat on the floorboards. I tried using a thicker carpet insulation which helped the heat issue, but not the sound issue. I installed the foil backed pad on the left front and rear floorboards as I needed more heat protection there and the non-foil backed pad on the right front and rear floorboards. Both types were relatively the same amount of difficulty for installing, but the non-foil backed pad conforms to the floorboard contours much better. The non-foil back pad is also easier to tear and damage (during install and during use). It seems like both pads do an OK job of reducing the heat, but I was more interested in lowering the noise level. I did notice a small amount of noise reduction on the highway, but not really significant. If you are expecting good noise reduction, this will not be what you want. I may try adding some different noise pads on top of this one to see if that helps. I will also put some in cargo flooring to see if that helps. The jeep also has a removable top which is fairly thin. I was hoping that I could use the non-foil pad on that too for insulation, however, it is way too fragile for this application, so I will keep looking for something for the top. I should mention that other folks said that this material arrive folded which made it a little challenging. Mine also arrived folded which was annoying, but I made it work. Others also mentioned that once this is stuck on something, it won't come unstuck. I had the same experience as well. If this stuff is mis-stuck, you are out of luck with removing it and re-sticking it. I cut mine to shape prior to removing the backing. Then removed a little of the backing at one time, stuck it in place, then removed a little more. This worked fine for me.Pros:- Affordable- Relatively easy to install- Sticks well- Seems to cut down the heat- Non-foil version conforms to contoursCons- Doesn't really cut down the noise much- The non-foil pad is fragile. Not sure how long it will last.- Tough to remove once stuck down
Cliente
Reviewed in Spain on September 14, 2019
La espuma se deshace y se marca y se rompe enseguida como si fuese una esponja,tendría que ser dura como.las esterillas del suelo de hacer yoga o un caucho mas duro y prensado,y el adhesivo una basura,no pega,se levanta al momento y no pega,y si pega se levanta al momento creando como bolsas de aire.
Fugi
Reviewed in the United States on August 14, 2019
I use this product to replace an original foam pad next to the motor on a sail boat.This product is much better then the pad and no more moisture or water , adhesion is good and you can overlap or double it.Before the diesel sound was present in the boat , I still hear the motor but it's much more quiet , definitely a good solution for sail boat and the price of a box is affordable.....I will use the rest on one of my antic car project..
Tharin
Reviewed in the United States on August 11, 2019
The adhesive is impressively tacky. If yours isn’t staying stuck then you didn’t do a decent job cleaning the panel surface beforehand. And you DID use a brayer, right? This is good stuff; don’t malign it if you’ve been sloppy.In spite of all the nonsense in the above description (WTF cotton???), this is just neoprene foam that you can stick on big panels to absorb a little bit of noise. It isn’t a miracle product and it can tear but it sticks like mad and you can NOT reposition it after a few seconds.Stick it everywhere. Don’t try for 100 percent coverage. Use it in your car doors to make your speakers sound better. Don’t use it to dampen panel resonance (that’s for heavy thin tarry butyl sheets) but do use this to quiet down spaces.I’m buying more.
RoxyK
Reviewed in the United States on January 26, 2019
No complaints with the seller, major complaints with the product. Backing will not peel off, normally backing comes off smoothly as you roll along. This does not, you wind up with a lot of little pieces to take off because the paper is very cheap and tears, very time consuming and disappointing. The foam does not stick well to anything except itself. It is impossible to take apart foam pieces that touch each other without destroying them. And since the backing doesn't peel off you will like I did, wind up throwing away enough of it that you will not be able to finish the job and have to buy more. (buy something else, this stuff is horrible.).I threw it all away after my first attempt folded over and could not be un-stuck.
Fernando
Reviewed in Spain on July 31, 2017
Excelente protector de calor para poner bajo el capot de cualquier coche.Como aislante acustico pues no he notado mejoria, tal vez porque es de 6mm, y tendria que ser mas gordo.Encuanto al calor, por mucho rato que este encendido el coche, el capot por encima esta totalmente frio.Trae un pegamento fuertisimo que solo da una oportunidad, como se pegue ya no se despega sin romper.
Customer
Reviewed in Canada on March 25, 2017
nice product, stick very good
Recommended Products