Your cart is empty.
Your cart is empty.QUICK HITCH BUSHING KIT - Many original 3-point hitch set-ups have thinner attachment pins that can cause your implement to jump out of the hitch. This hitch kit will reduce and remove spacing for a better, more secure fit. It is compatible with iMatch Quick Hitches and Category 1 implement hitches. It comes with many coated steel components. This Quick Hitch Bushing Kit includes 2 Steel Shoulder Bushings, 2 Top Link Bushings and 2 Roll Pins and is easy and simple to install
Josephus74
Reviewed in the United States on February 13, 2024
Worked great, fit perfectly on a new 2024 JD RCM6 to connect to I-match quick-hitch. Easy install although the split roll pins took a bit of hammering to get seated well, took all of 5 minutes to put them on.
Brian R
Reviewed in the United States on September 5, 2023
These are excellent quality bushings. Added to my iMatch and they fit and work like a charm. Very happy!!
Dads Barn
Reviewed in the United States on July 6, 2023
Bought another 3-point implement and needed to make it work with my iMatch. Implement manufacturer wanted more than this cost, plus shipping! These accomplished the task, although the implement's tolerance for the toplink was a little tight and I had to force the arms apart to get the bushing in. But, other than that, this product is exactly what I needed and works perfectly!
ADodge
Reviewed in the United States on July 24, 2023
These are the same as John Deere iMatch bushings at half the price. Great deal!
Darrin B
Reviewed in the United States on May 23, 2023
Great product and almost half the price of john deere brand
Shawn
Reviewed in the United States on January 6, 2021
And an FYI on the install. Roll pins are designed to fit extremely tight. My advice is to use a bench vise to start them off. I did that for each side and total install time was less than 5 minutes.Reviewers that complain about how tight the roll pins go in, are ignorant to their intended purpose.
Glenn
Reviewed in the United States on January 22, 2020
All components fit well. Retaining pins were a little tight but that's probably because the disk I was attaching bushings to was old and rusty. I'll admit, I was pleasantly surprised when the bushings slipped easily over the existing 3 point rod and the retaining holes actually aligned perfectly. Took all of 15 minutes to install. The biggest problem I had was getting the rusty bolts on the disk loose to install the hook bushings. I replaced the old bolt with a new stainless steel bolt so I don't expect rust problems. If your tractor is already setup for Quick Hitch, I highly recommend this for any 3 point implements you have. It's a lot easier to install this on your implements than it is to remove the quick hitch on your tractor and then use the 3 point setup
FR3QUENT PURCHASER
Reviewed in the United States on December 9, 2019
I was having a hard time using my box blade to push snow in reverse on my John Deere 1025r because I was using it with its original three point hitch set up (the thinner attachment pins). After having it jump out of my quick hitch attachment several times during the last snow storm, I decided to look these up on Amazon rather than take time to travel 20 minutes one way to the John Deere dealer. They arrived, I walked out to the box blade, lined up the bushing's holes with holes on my box blade pins and tapped in the metal bolt like deal meant to hold it in place. Was done in less than 5 minutes. Works perfectly now. There is an extra bushing piece left over. Must be for other set ups unlike mine, I only needed the one bushing piece.
Recommended Products
