Your cart is empty.
Your cart is empty.Material is case hardened 1018 steel with black oxide finish. 5/16"-18 Thread. 1/2" Table slot. 7/8" Base size. Measures 1/2" width by 7/8" height.
shiny knight
Reviewed in the United States on October 2, 2024
For machinists purposes these fit the slots just as described.
Kevin
Reviewed in the United States on March 26, 2023
Fit my clausing 8520 perfect.
Robert D Gregg
Reviewed in the United States on November 7, 2022
I use these with my milling machine table. They're very well made and I am very pleased with them.
William Weldon
Reviewed in the United States on June 12, 2021
Threaded hole not in center of nut, threaded hole not perpendicular to surface of nut, sides of nut not square.
Customer
Reviewed in the United States on June 10, 2021
Not what I was expecting. Thought the bolt hole was smaller but the entire t-slot is smaller. Too small to use in the Tacoma rail system.
Mark
Reviewed in the United States on March 12, 2020
These T-nuts are well made, I may have chosen the incorrect size for my application due to slightly excess play in the fitment to my table. I may search for a bit larger size that would fit better. No fault of the product, just in my chouces.
Kevin A
Reviewed in the United States on October 20, 2019
Definitely worth it to buy these USA made T slot nuts. I had some chinese ones someone had given me and they didn't even slide in the slots correctly. These will save you so much time and trouble
Chris
Reviewed in the United States on September 20, 2018
Very nice t-nut. Good fit and finish. Be advised that they are tapped through, meaning the clamping stud can thread all the way through the bottom. This could damage your machine table if you aren't careful.
Recommended Products
