Your cart is empty.
Your cart is empty.Material is case hardened 1018 steel with black oxide finish. 1/4"-20 Thread. 5/16" Table slot. 9/16" Base size. Measures 1/4" width by 9/16" height.
Stephen Cook
Reviewed in the United States on March 25, 2024
Have bought this same Te-Co t-nut from other websites and never had a problem with them being only partially threaded.Ordered a total of 300pcs through Amazon and every one was only partially threaded.
David Morris
Reviewed in the United States on May 22, 2023
The nuts that I received were not threaded all the way through. Tried to finish the thread, but these are hardened steel and broke the tap. I wasn't able to use these for the purpose I ordered them for because they were not fully threaded.
Michael Deen
Reviewed in the United States on October 11, 2023
Looked didn’t fill my needs
Kenny Adams
Reviewed in the United States on July 19, 2021
Worked as advertised
Alan
Reviewed in the United States on March 17, 2021
For some inexplicable reason, the threads don't go all the way through the nut. This leaves only about 2 threads for the bolt/stud to "catch", unless the bolt/stud is bottomed-out in the nut. Two threads is not enough to hold any serious clamping load, and bottoming-out the bolt/stud will ensure the load will be unevenly distributed across the threads since the bolt/stud will wind up being slightly cockeyed (not in-line with the axis of the hole) when you do that. Since they're hardened, re-threading them yourself is not an option. Not recommended unless the design is changed so the threads go all the way through.
Gray One
Reviewed in the United States on February 6, 2021
When I went to use them I discovered that the threads do not go completely through the T-nut. The #7 hole is drilled for them but the tapping of the threads is incomplete. The steel is hard and I couldn't finish tapping the hole. This product is a complete waste of money.
ThicketMatt
Reviewed in the United States on November 20, 2021
For those that are giving a low rate because they are NOT threaded all the way through, please note that is intentional. These are for holding down work on a machining mill or drill with a slotted table. If the bolt could go all the way through it could contact the base of the table, and instead of pulling the work piece down, it will jack up and damage the table. If you need it all the way through run a tap through it to complete the threads.
TFred
Reviewed in the United States on July 14, 2019
Threads were 1/4x20, but undersized - poor quality control - not usable. Really disappointing considering they came from Small Parts
Jean-Marc MALETTE
Reviewed in Canada on May 17, 2019
Table de fraiseuse
Recommended Products
