Your cart is empty.
Your cart is empty.Material is case hardened 1018 steel with black oxide finish. 5/16"-18 Thread. 1/2" Table slot. 7/8" Base size. Measures 1/2" width by 7/8" height.
Paul Lamberty
Reviewed in the United States on February 18, 2025
The T-slot nuts are very nice, however only 4 were in the package of 5. Disappointed, but not worth the time to return and get a replacement set.
Satisfied Customer
Reviewed in the United States on April 2, 2024
Would buy again. Best price I’ve found
David Swift
Reviewed in the United States on December 10, 2021
I don't know why I didn't buy these 20 years ago. Far better than bolts and washers to secure a vice to my drill press.Note that they are not threaded all the way through so short bolts are needed.
otbrenner
Reviewed in the United States on January 31, 2018
As others have noted, bolts will not go clear through this nut. the threads seem to end. not a terrible issue if you size your bolt right and use washers as needed to tighten.Other than that... quality seems up to snuff
John in Tennessee
Reviewed in the United States on June 9, 2014
Nice quality and finish. You cannot thread a stud past the bottom of the nut. The studs lock in to the bottom threads of the nut so the stud stay in place while you are tightening and loosening the hold down nut.
Recommended Products
