Shopping Cart

Your cart is empty.

Your cart is empty.

Sturdy Built Single Axle Galvanized U Bolt Kit for mounting Boat Trailer Leaf Springs for 2x2 axle - 5 1/4' Long

5.0 (8) Write Review
Free shipping on orders over $29.99

$37.90

$ 17 .99 $17.99

In Stock

About this item

  • All Hot-Dipped Galvanized Parts, Perfect for Fresh Water or Saltwater Boat Trailers, or Utility/Land Trailers in Icy or Coastal locations.
  • Complete Single Axle Kit: Includes All of the Galvanized Hardware and Parts Pictured. Enough U Bolts and Plates to mount a Single Axle to Your Trailer.
  • Fits a 2x2 Square Axle. The included U Bolts and Plates are designed to fit around a 2 inch by 2 inch Square Boat Trailer Axle.
  • Square U Bolt Size: 1/2 inch Diameter x 2 inch Inside Width x 5 1/4 inch Inside Length


All the hardware to mount a single axle to your leaf springs together in one kit. The kit is designed to install a 2 inch by 2 inch square axle, and the Hot-Dipped galvanized coating on all of the parts helps prevent rust in the harsh marine environments. This U-Bolt Kit is used to mount your trailer leaf springs to your axle by using (2) U-Bolts and (1) 4 hole plate on each side. This kit includes (4) square U-Bolts, (2) Galvanized 4 Hole Mounting Plates, and (8) galvanized nuts and lock washers, so you can attach both springs to a single axle. This Trailer U Bolt kit is most common on boat trailers with either 2,220 lb or 3500 lb trailer axles using 1 ¾ wide springs, but it will also fit 2-inch wide springs.


Lindsey Boggs
Reviewed in the United States on June 22, 2024
These fit my axle and leaf springs perfect. The galivinize will bee good for the saltwater application.
William tormondsen
Reviewed in the United States on November 7, 2022
Boat trailer
Modesto suarez
Reviewed in the United States on November 18, 2021
Parts arrived earlier than expected. They definitely look sturdy. Will buy again
Sailing Ranger
Reviewed in the United States on January 28, 2020
These parts were really well packed and arrive in perfect condition. The parts are hot dipped galvanized and should last decades on my boat trailer. I'm using these to attach guide poles to the trailer frame. They are replacing the flimsy barely electroplated mounting hardware supplied with the guide poles. Definitely recommend these parts.
Boatboy1
Reviewed in the United States on September 22, 2019
I like that everything was in one kit, including everything I needed to mount My trailer axle to the springs. There seem to be good galvanized coating And everything fit as described
Customer
Reviewed in the United States on September 12, 2019
fit right and worked good .
Paul
Reviewed in the United States on July 31, 2019
Solid parts, coated well, and installed them with no problem. They fit snug on my 2” wide axle.
Jat
Reviewed in the United States on July 24, 2019
These were used as part of a hub/axle rebuild and worked perfectly. Good value as well.