Your cart is empty.
Your cart is empty. This is high torque Nema 17 stepper motor with 1.8 deg. step angle (200 steps/revolution).
Each phase draws 2A, allowing for a holding torque of 59Ncm(83.6oz.in). It's very good choice for 3D printer.
Electrical Specification:
* Manufacturer Part Number: 17HS19-2004S
* Motor Type: Bipolar Stepper
* Step Angle: 1.8 deg.
* Holding Torque: 59Ncm(83.6oz.in)
* Rated Current/phase: 2.0A
* Phase Resistance: 1.4ohms
* Inductance: 3.0mH+/-20%(1KHz)
Physical Specification:
* Frame Size: 1.65" x 1.65" (42 x 42mm)
* Body Length: 1.89" (48mm)
* Shaft Diameter: 0.2" (5mm)
* Shaft Length: 0.94" (24mm)
* D-cut Length: 0.59" (15mm）
* Number of Leads: 4
* Lead Length: 39.37" (1000mm) with connector
* Weight: 390g
Connection:
Black(A+), Green(A-), Red(B+), Blue(B-)
Warning:
Make sure the motor connect to a constant current or chopper drive controller before you test motor.
Connecting the motor directly to a power supply will destroy the motor.
Youssef
Reviewed in the United States on June 3, 2024
Great Quality and very quick and sturdy.
MC1457
Reviewed in the United States on April 9, 2024
Using two of these for A/B motors on a Voron Trident (corexy). I am using the following settings for X and Y (Klipper):[stepper_x]rotation_distance: 40microsteps: 16full_steps_per_rotation:200[tmc2209 stepper_x]# 2.0A * .0707 = 1.4. Lowering to 1.1 after overheating issuesrun_current: 1.1sense_resistor: 0.110stealthchop_threshold: 0
squirrel
Reviewed in the United States on October 21, 2022
Installed it on the Y axis of my ender3v2 for more oomph.
César Uriel Coto Coazozon
Reviewed in Mexico on April 14, 2022
Una buena compra.El vendedor envía en un buen enpaque, los motores se ven de calidad tanto en el cableado como en el cuerpo del motor
DOMINOE
Reviewed in the United States on November 22, 2021
Two sets of these got me to 500mm/s at 10,000mm/s² on A/B and 300mm/s at 2,000mm/s² on Z on my Voron V2.4 build.
Mike M
Reviewed in the United States on December 5, 2018
According to the item, I ordered 6 (3x2) of the 59Ncm bipolar stepper motors and received 6 32Ncm unipolar stepper motors.
Kyle K.
Reviewed in the United States on May 3, 2016
I have purchased quite a few of these motors and have been very happy with the performance. I have them installed on both a Kossel Mini 3d printer (axis drives and extruders) as well as an X-Carve CNC router. For their size they do a great job -- they run cool and have much more torque than similar sized NEMA 17 motors I've used in the past.
Adrian AZ
Reviewed in the United States on April 30, 2016
Working as expected. Stay cooler than mallet steppers they replaced.
CutterComp
Reviewed in the United States on April 16, 2016
works great with the Gecko drive.
Recommended Products
