CHINOABM
Reviewed in the United States on February 8, 2025
Not bad for the price.
Customer
Reviewed in Canada on January 28, 2025
Audi steering knuckle. Appears to be correct although not installed yet. Great price, here in 4 days international to Canada...impressive!
Customer
Reviewed in Canada on January 28, 2025
Product appears to be correct although not installed yet. Arrived in 4 days international delivery and a fantastic price!
Carole
Reviewed in Canada on March 28, 2024
Was satisfy with this purchase
Ghaith Baban
Reviewed in the United States on February 10, 2024
Perfect fit
Anastasio Sarigiannis
Reviewed in the United States on December 16, 2024
The top pinch bolt on my Audi A4 B8, that holds the two upper control arm ball joints in, snapped when I was try to disassemble the drivers side front suspension. The bolt was stuck in there for good, so I unfortunately had to replace the entire knuckle. This replacement knuckle was an exact fit. I put a new hub bearing unit in it, and transfer the hub flange from the old bearing unit as well. I also put in a new ABS sensor and ordered new upper control arms, as the original ones were stuck in the old knuckle. And if I was going to go to this much trouble, I though I may as well put new upper control arms in. I am glad I found this knuckle on Amazon and got it quickly to get my car back on the road.
Larry
Reviewed in the United States on November 15, 2024
Looks good and was identical to original.
Dennis moyes
Reviewed in Canada on January 23, 2024
Appears to be a quality part. Everything lined up and fit together properly.
Joel
Reviewed in the United States on September 15, 2023
2004 Audi B6 A4 Quattro Sedan M/T. For a fraction of the cost for one from Audi, it fits good however there is a slight dimensional difference near where the hub mounts. When installing the hub, it sits slightly outwards away from the car, causing the cv axle abs ring to come into contact with the knuckle, causing the axle to bind and not move. Currently we are trying to put thin washers between the axle and the hub to back it out >1 mm to correct this issue.
Brandon chowning
Reviewed in the United States on November 30, 2023
Fit perfectly. Hundreds cheaper than dealer cost.
George emberley
Reviewed in Canada on October 18, 2023
Received in good order and condition and on time
AC
Reviewed in the United States on August 5, 2021
Perfect fit for 8K0407253AB - used on a 2010 (nov 09) b8 a4 avant 2.0 quattro. every hole was perfectly aligned. control arms, pinch bolt, hub assembly, steering ball joint, both control arms, abs sensor, cable clips, caliper carrier, heat shield, etc. it was nicely packaged in bubble wrap and bagged. looking forward to driving spirited again after a cracked pinch joint on the VAG piece.