Your cart is empty.
Your cart is empty.Standard Motor Products, Inc. - Condenser Ign (FD-75T)
Don Roberts
Reviewed in the United States on August 26, 2024
I have not used it yet, but it tastes good.
diego
Reviewed in the United States on July 5, 2024
Awesome.
Anita Hartling
Reviewed in the United States on October 4, 2024
Worked as discribe
david malmsten
Reviewed in the United States on April 16, 2024
I bought a new condenser from a John Deere dealer to replace a very old one, along with new points, rotor, cap, wires, plugs, & distributor shaft bushing. My tractor ran poorly and misfired constantly after replacing everything. Hours of troubleshooting revealed no certain fault. I ordered a Standard FD75T condenser even though my made in china Deere brand condenser tested fine at .27 microfarads. The Standard condenser I received is made in Mexico despite the listing saying made in china. It tested at .21 microfarads. I did not have much hope of improvement since everything in the ignition system was already replaced. Incredibly the engine fired right up and ran like a top after installing this condenser! I suspect the dielectric material was breaking down in the chinese condenser causing an intermittent misfire. This insulation breakdown would not show up on a capacitance test. Good luck with your ignition problem.
johnmiles
Reviewed in the United States on September 22, 2022
Everything was perfect fast delivery and worked great
Don P. Jones
Reviewed in the United States on December 13, 2021
Worked for my Bosch 019 distributor. Liked the fact that the mounting clamp is not secured to the condenser so you can adjust it as needed.
Customer
Reviewed in the United States on May 29, 2019
exactly what I needed
Recommended Products
$11.99
$ 4 .99 $4.99