Your cart is empty.
Your cart is empty. Please review all product information to ensure that this product is compatible with your unit.
This is a Quality The ROP Shop Brand Product
A Message to the CustomerThe ROP Shop staff constantly strives to provide clear and concise product information. We understand that sometimes it can be difficult to confirm product compatibility. It is your responsibility to confirm this is the correct product you need; therefore, we encourage all customers to fully review the information provided in this listing prior to purchase. Nothing is worse than having to return a product, trust us...we get it. Let's work together to avoid this! If you are unsure as to whether or not this is the correct product for your unit, please ask. If you seek assistance we will need as much of the following information as possible, if applicable, to help you find the product you are looking for: Model and/or Sub-modelSpec and/or Type NumberCode and/or Serial NumberYearEngine Horsepower
Our knowledgeable product specialists are always willing to help you verify product fitment. Stay rugged, my friend.-The ROP Shop Staff
Tony Gragg
Reviewed in the United States on June 26, 2024
Perfect everything work just fine good deal good prices appreciate it
Thomas F. Steinhauer
Reviewed in the United States on November 24, 2024
Used on a snow blower engine
Jeffrey S. James
Reviewed in the United States on October 10, 2024
Yes
Spit
Reviewed in the United States on August 29, 2023
Installed in a 30 year old Tecumseh 5 HP engine… brought it back to life
jLj
Reviewed in the United States on June 8, 2022
Worked well.
Robert J. Delesantro
Reviewed in the United States on May 26, 2022
I liked that it was an exact fit for my vintage flymo hover mower. Tecumseh engine.Easy to install.
Customer
Reviewed in the United States on February 5, 2022
my snow blower runs like new.
Todd Austin
Reviewed in the United States on November 17, 2022
The points and condenser fit, however the point had some kind of gray corrosion/film on them. I had to take them apart and sand the contact points. Of course, that was after having installed them and then troubleshooting the system until I found out that there was no connection. This was part of a system replacement that included Points, Plug, Condenser, and Coil. So, there was a bit of assembly, test, disassembly, test, Ect. New points should not have to be sanded to make work. It cost me several hours to find the problem. Motor is up and running now. If you buy these check them before you install.
Recommended Products
$33.99
$ 16 .99 $16.99