Your cart is empty.
Your cart is empty.The Square D By Schneider Electric Ground Bar Kit is an important accessory in your home or business electrical load center. This 9 Terminal Ground Bar Kit is used in load centers, CSED devices and NQOD and NF panel boards. Includes 9 available terminals, and is suitable for (1) #14 to #4 or (2) #14 to #12 Cu, or (1) #12 to #4 or (2) #12 to #10 Al.
bill atteberry
Reviewed in the United States on January 28, 2025
Just what it supposed to be
bcpolaris
Reviewed in Canada on January 19, 2025
Can be used on any sub panel.
Dennis Rasmussen
Reviewed in the United States on August 6, 2024
I added an electrical breaker box in our shed and needed a ground wire connection and this worked out well.
Ron
Reviewed in the United States on April 14, 2024
Fit in the panel as described.
Tombo
Reviewed in the United States on November 29, 2022
I got this because Amazon recommended it for the breaker box I ordered. But this did not fit the box - this has 2 mounting holes and there were not two holes in the box that lined up with this, so I had to install it with only one mounting screw. Probably ok, but not preferred. I took off a star for that, and one more for it arriving late.
We love critters
Reviewed in the United States on December 30, 2019
It fits my Square D panel box perfectly. I would have never thought one screw would hold it but it has little nubs for alignment and I works great!
Steven L.
Reviewed in the United States on December 27, 2019
Don't install a panel without a ground bar. Worth every penny. Good quality.
Ray Sadesky
Reviewed in the United States on November 6, 2019
Good ground block. Fits perfect in square D load center.
MussSyke
Reviewed in the United States on January 30, 2015
These work in QO and Homeline panels by Square D. Typically, they're used to add a separate ground bus to a subpanel (since the neutral and ground are ONLY connected in the main panel). They work with 0, 1, or 2 factory provided machine screw holes. In the case of no holes in the panel, they'll ask you to use an odd sized drill bit - use the next lowest common size, and it will work fine. Accepts up to 4 AWG.
Recommended Products
