Your cart is empty.
Your cart is empty.Spare blade to fit CJP5 - No.5 Jack Plane. Ground and hardened carbon steel Ideal to have as a spare, or to be bought as a replacement. We offer spare blades for all of our Carpenter's Planes. Spare blade to fit: Spear & Jackson 'CJP5' Jack Plane.
Christopher
Reviewed in the United States on March 5, 2025
Works wonderfully just a fair amount of flattening on blade and body. Also a bit of film coating that looks worn. I tried mineral spirits but that only helped with the coat of oil they protect it with for shipping.
Julia
Reviewed in the United States on March 12, 2025
Hello. I received plane number five. It is heavy and solid - it inspires confidence. I removed the knife - the sharpening is almost even, but rough, for a good result it is necessary to sharpen it on special bars. I read a lot of comments in which they write about the uneven surface of the plane sole - nothing like that. I measured it with a ruler - everything is perfect. Only all the metal surfaces are covered with a thin layer of varnish, you can see from rust. In general, I am very pleased with the plane I bought for such a small price. Thank you Spear & Jackson! đ
Mr. R Longhorn
Reviewed in Belgium on February 23, 2025
Excellent build quality, as one would expect from S & J.
Ben Chai
Reviewed in Australia on February 15, 2025
Terrible packaging. Item should have been packaged in a box rather than a bag. Product itself if ok for the price.
John-Michael Seeley
Reviewed in the United States on September 21, 2024
Once you get it set up I couldnât see anything wrong with it and i was trying. the iron is decent sharp out of the box and didnât dull very fast. Why is it so cheap? Where else is this company taking shortcuts to turn a profit if not with the product itself. I worry that the workers are there against their will
Steven Corley
Reviewed in the United States on August 30, 2024
Couldnât be happier! Open the box, set the blade and started working on this piece of Walnut. Outstanding plane for the price and very nicely built!
Portland Mike
Reviewed in the United States on June 15, 2024
Feels good. Working well after honing all the mating surfaces. The blade didnât require that much.If you want an out of box ready to go planer buy electric. Even at 10x the price youâll eventually need to tune it.
ADAM B
Reviewed in the United States on May 17, 2024
I will admit i had very low expectations for this. Youtube woodworkers have jaded me to only valuing a plane if its an 1800 stanley. or priced in the $300 range. This was a gift from my wife. and i fake smiled as i opened it. threw it on a shelf to rot. But when i couldn't find my $200 jack plane. I grabbed this POS. Boy was i wrong. It cuts like a dream. sharp and true out of the box. I made no adjustments before. and it gave consistent even thin paper like shavings. and kept performing. Pine, cedar, like butter. Walnut, maple (curly even) smooth as silk with no chatter on the curly. I'm impressed. if you guys wanna hook me up with a whole set. I'll gladly preach your sermon. well done
Mark Hayes
Reviewed in the United States on February 2, 2024
The plane is built solidly, but the sole on all of the Spear & Jackson planes I have bought have been nowhere near flat. When viewed from upside down, the heel and toe of the plane is significantly higher than the rest of the sole. The sides of the sole have also been higher than the center of the sole near the mouth. The machining on the frogs on the planes I bought was really rough and required some filing and sanding. The blade edges have not been square to the sides on any of the three Spear & Jacson planes I have. The primary bevel edges on the plane are very concave and not a true 25 degrees and were not cut straight on any of my planes, both of the edges protrude from the mouth farther than the center of the blade and the blade was not flat on any of the planes I bought. I had to sand the chip breaker on my number 4 and number 5 planes so they would rest flat on the blade and reduce clogging. The blades need sharpening quite often as well. The depth adjustment on my number 4 and 5 planes is terrible, the yoke is too small for the depth adjustment knob so I have to make three to four full turns to engage the blade. I've actually had to buy a yoke for my number four since the one I got was junk, my number 5 is a little better. To make matters worse it can slip out of adjustment on all three of my Spear & Jackson planes once in a while, which starts the headache all over again. On the more positive side, once I did all of that work, I have been able to take consistent shavings as thin as 0.005 inch, but that is only with a very sharp blade. If you don't mind putting in the work, and figuring out how to troubleshoot problems, it can be a great plane. I really wish they would spend a little more time machining the parts smoother and fitting the parts to each other more carefully. They really need to work on their blades and/or use higher quality steel and find a better way to cut the primary bevel.
openminded
Reviewed in the United States on December 31, 2024
I read the reviews and knew that it needed work going into it. For the price I figured it was a good plane to learn on. I bought an extra blade to use that for scrubbing. I was hoping to get lucky that the sole was square to the side for shooting but no such luck. Some searching around said you can use the lateral adjuster to compensate.Update. I flattened the sole and lapped/sharpened the blade. The sold did'nt come out perfect but much better and the blade cuts well too. For the price this is a great plane to learn on and use without fear of breaking something.
Mar Mar
Reviewed in Japan on October 27, 2024
Good
Flyman
Reviewed in Germany on December 6, 2022
Als Ersatz fßr meinen Record No.5 aus den 1950er Jahren. Macht was es soll. Kein Wundereisen, aber mit guter Standzeit und langer Arbeitsschärfe. Auch fßr Hartholz geeignet. Guter Ersatz des Originals. Preis / Leistungs ist ausgezeichnet.
Hobb
Reviewed in Spain on October 13, 2020
Las caras fresadas hacen que como garlopa la base sea buena, si bien el material es algo blando y se raya con facilidad, la cuchilla si es de calidad.No he podido perder todo el tiempo que me gustaria ajustandolo, pero en un ratito de pruebas:- El mecanismo de ajuste lateral se mueve solo, no aprieta lo suficiente. Hay que poner la palanca muy ajustada para que se quede quieto.- La boca es muy ancha, inmensa. Hay que adelantar la cama (frog) para intentar cerrarla un poco.- El hierrecito que se mete en el contrahierro para ajustar la profundidad es demasiado corto y en la posicion de mas arriba se sale de su agujero y deja de sujetar.- con una lima, he tenido que "afilar" el contrahierro, para que las cintas puedan salir libremente.Despues de estos ajustes, funciona perfecto.TARDO 3 MESES EN LLEGAR
Recommended Products
$14.85
$ 7 .99 $7.99
$24.99
$ 10 .99 $10.99