Your cart is empty.
Your cart is empty.Give Your Small Block Chevy Engine a new look with our 205 Piece Stainless Steel Hex Bolt kit!! Our special intake washers are 1/8 thick. The bolts in this kit are made from 304 stainless steel. SEND A MESSAGE IF YOU HAVE AFTERMARKET COMPONENTS.
This Bolt Kit Fits All 265, 283, 302, 305, 307, 327, 350 , and 400 Chevy Engines.(Non-EFI). This is a complete high quality stainless steel hex bolt kit. The kit includes individually packaged and labeled component kits for the following items:
Intake Manifold- Timing Cover- Water Pump- Oil Pan- Thermostat Housing- Distributor- Coil Bracket- Fuel Pump- Valve Covers- Headers- Crank Pulley- Fan Pulley - Carb Stud Kit
The carb stud kit fits Carter, Edelbrock, or Holley Carbs. The studs have an internal hex used to install them in your intake manifold. If you are using a Quadrajet carb, just let us know with your payment and we will include a mounting bolt kit for you!
Header Bolts (3/8-16 x 1 Allen Bolts) And Our Special Small OD Header Washers Are Included With Each Kit! These extra thick washers are designed to Clear Large Tube Headers.
LightingShark
Reviewed in the United States on August 13, 2024
I have a 1989 Pontiac Firebird with a 350 TPI and couldn’t find a kit for that so this TBI kit ended up working out really good. I lost a lot of bolts in the process so this kit really helped out and has a lot of stuff.
not happy
Reviewed in the United States on April 10, 2024
awesome packaging.. !! all bolts packaged separately for its respective area on the motor !!
Knightrider
Reviewed in the United States on April 11, 2022
Only 3 items fit my small block chevy. The exhaust bolts were too short,water pump fan pulley bolts were wrong thread, the fuel pump bolts only one bolt fit.
Donnie
Reviewed in the United States on July 19, 2019
Good quality
Jonathan mathews
Reviewed in the United States on October 23, 2019
This is simply a must have if you are building a sbc the bolts are good quality and everything is individually packaged and labled.
BrandonD
Reviewed in the United States on April 4, 2019
Very high quality set of hardware for your small block chevy. Everything comes separated in labeled bags. Very helpful, However if you are expecting this hardware set to be shiny they ARE NOT polished. Just a flat stainless finish...
viperjuice
Reviewed in the United States on May 4, 2018
Very nice setup for rebuilding an engine. Granted it doesn’t have bolts long enough for factory exhaust manifold but does have nice header bolts. I’m very impressed with the product you get as well as packaging.
TommyGun
Reviewed in the United States on November 23, 2018
impressive to say the least! quality is very good and packaging is something I would expect at ARP levels of cost! everything was correct and packaged individually by what it was for! awesome!!
Recommended Products
