Your cart is empty.
Your cart is empty.The Smart Stat IV Heat-N-Glo Fireplace Remote Control by Skytech provides wireless thermostatic and timer control of a gas heating fireplace with the simple click of a button. The remote control transmitter runs on (2) 1. 5V AAA batteries and features an LCD display that uses a 5 button (MODE/UP/DOWN/SET/TIMER&TIME) interface to communicate wirelessly to a 110V AC receiver. The receiver connects to all standard millivolt valves. Enjoy the ambience of a cozy fire, control the temperature of the room, and use the timer function all without sacrificing the comfort of your seat using this fireplace remote control from Skytech.
Aaron Camp
Reviewed in the United States on February 22, 2025
Easy hook up and works great
TS
Reviewed in the United States on February 15, 2025
This was a replacement for a SmartStat II (Dec 2009 model). The buttons on the old remote were always very difficult to push and I was concerned that the new one would be the same but they weren't. This new remote had the same features (on/off/thermo) and the buttons were easy to push with a crisp response.The receiver had the same wires as the old one, one 120V plug and two red wires, same as the previous model so it was an exact swap out. It didn't require any code setting or programming either so it was up and running within a few minutes.The only difference I see is that the old one (Smart Stat II) had an option to use batteries in the receiver in case of a power outage. This one does not have a battery backup option. I had never used that option in 15 years so wasn't an issue for me.Great value, easy to connect.The only difference I see
BS
Reviewed in the United States on January 24, 2025
The install went perfect and the remote with the temperature control is great. Saved a ton of money doing it myself.
Customer
Reviewed in the United States on January 24, 2025
Easy to hook up and works great.
Donald W Pruitt
Reviewed in the United States on January 10, 2025
Easy to install and set up, took less than 10 minutes....
Dennis B.
Reviewed in the United States on December 28, 2024
Arrived fast , easy hookup, works fine so far.
Customer
Reviewed in the United States on December 19, 2024
Its replacing a Heat n Glo receiver that finally quit after 27 years. This receiver was easy to install. The remote that came with it works but temperature varies from 2 to 6 degrees when using Thermo. Good price.
Tumbler Bob
Reviewed in the United States on November 14, 2024
Arrived quickly and was easy to install. Appears to be a direct replacement for my failed 22 yr old Smart-Stat II/III remote & receiver on my Heat-N-Glo fireplace.Before ordering these new parts, I changed batteries in the old remote and it still would not turn on the fireplace. I confirmed the receiver below the fireplace was getting power. The fireplace ignited when I manually moved the receiver switch to "ON". (The receiver has a slide switch for OFF/REMOTE/ON). However, the fireplace did not go off when I slid the receiver switch to "OFF".The new remote & receiver are working great! Happy that I purchased this over the more expensive Skytech Smart Stat II/III Fireplace Remote Control for Heat-N-Glo (original remote was a Skytech Smart Stat II/III).
Recommended Products
$134.10
$ 60 .99 $60.99
$145.00
$ 71 .99 $71.99
$101.99
$ 43 .99 $43.99