Your cart is empty.
Your cart is empty.Product Description
Sinoking 10T Recovery Winch Snatch Pulley Block
- 22000LB/10T Max load.
- Swivels open to accept line with no disassembly
- Reduces winch load and heat, helps increase winch pulling power
- Accept both wire and synthetic rope 3/8 in. ~ 1/2 in. diameter
- Grease injection hole
Breaking strength test
Pulley ancoring
You may need
Double/triple line rigging
Harland L. Matthews
Reviewed in the United States on December 6, 2024
Purchased this to use with a winch setup that I was adding to a car trailer. I used this once and it worked flawlessly!
Rodney Hermio Vupperschlitz
Reviewed in the United States on November 6, 2024
I use it to change direction of pull when directional felling of trees, so they don't fall on my head! They seem well-built. I cannot verify that they can actually handle 22000 pounds, as a 1/2" rope would break well before that load. I use a 2000# rated rope come-a-long.
John Mullen
Reviewed in the United States on September 8, 2022
Light weight well built
Robin
Reviewed in the United States on June 6, 2022
I use this to pull trees over on my property that are leaning toward my house. Tension them up to a good Arborist rope and cut it down. Its heavy so be prepared
Yes2God
Reviewed in the United States on April 28, 2022
Pulley just as advertised. Rugged and held together with a big bolt instead of retaining rings. Much sturdier.
zane halfaker
Reviewed in the United States on April 8, 2021
Quality made and it works great. A must have for vehicle recovery.
Jeremy D.
Reviewed in the United States on September 20, 2019
Very well built, but no directions were included about disassembly if need be. I would purchase again.
tacomuncher
Reviewed in the United States on August 27, 2019
Very nice fit and finish. Rigged up on Cadillac hill after getting stuck in someone else’s ruts. Performed as expected. Also has zerk fitting.
Recommended Products