Your cart is empty.
Your cart is empty.Rough CountryΓÇÖs 7 Degree Tapered Reamer aids in the installation of ball joints or tie rod ends to spindles. With a durable construction and 1/2in shank, this handy tool is a must-have to complete your installation.
shawnM
Reviewed in the United States on January 17, 2024
Very sharp. Worked perfect to cut new taper for Chevy 1 ton end links I put on my tractor.
Brian Sosebee
Reviewed in the United States on April 4, 2024
Go slow and use a good cutting oil . I used WD40 penetrating gel and works well .
Benny
Reviewed in the United States on November 28, 2023
Worked as it was designed
Angela Summers
Reviewed in the United States on April 6, 2023
The reamer shank bent on first use. The item is directly from their own Amazon store. Amazon sends you to rough country for support and they will not help because they “don’t have an order number” directly through rough country. Do yourself a favor and order from somewhere else. There are other companies that sell and support these reamers.
ellis jacobs
Reviewed in the United States on April 18, 2023
I have a big drill. Glad i did. Im not sure a cheap drill could handle it. I used mobil 1 cutting oil on the bit. Was kind of hard to do but all went good. Take your time when it gets close to correct dept.
shawn
Reviewed in the United States on September 8, 2022
Got the job done. Cut pretty good
Mickey Young
Reviewed in the United States on September 28, 2022
Unfortunate that this toll does not come with the steering kit it’s mainly for. Works great for its intended purpose, just take your time using the tool so you don’t break it.
Kyle Brown
Reviewed in the United States on February 28, 2022
Bought this to ream out some 7° inserts I bought for the TRE flip project on my 96 f150. I bought JK inserts that were the correct pitch but wrong diameter. Used this reamer to open them up to fit which worked beautifully without taking too much material. The new inserts are steel opposed to the knuckle which is cast iron, so I was a little concerned it would dull prematurely. However it worked flawlessly and the reamer is ready for the next project should I need it.
Kevindavis
Reviewed in Canada on December 3, 2022
cut through knuckles ok but couldnt cut through pitman arm. the pitman arm was a 6 inch drop arm, not sure if made out of harder metal or not but that shouldnt matter, if you are installing HD steering chances are you are lifted more than 6 inch. ended up having to buy a regular ream from a discount store, ream it most of the way with that, (regular ream cut through pitman arm just fine) then adjust the taper with a dremel, then do the final pass with the 7 degree ream.. turned a simple install into a full day never heard of RC reams being poor quality but it seemed like it this time, i do have an extensive automotive background and know drilling holes and reaming
Recommended Products
