Your cart is empty.
Your cart is empty.Front mounted hitch receivers allow a variety of accessories to be mounted on the front of trucks, vans, or SUV’s to perform tasks that make outdoor adventures and activities easier and more fun. Accessories are easily interchanged, so the receiver is a practical and versatile addition to sporting and work vehicles. All front mount receivers have a 2” square receiver tube opening and all attachments are J-Pin ready. Front mounted receivers offer a secure and useful attachment point and offer 9000 lbs. of line pull and 500 lbs. vertical load. The METALSHIELD protective coating process is a three step finish consisting of a rust inhibiting primer, dipped E-coat electrostatic coating to insure total finish coverage and finally an outer powder coat finish for durability. The METALSHIELD process is an OEM compatible finish providing the best corrosion protection over brands that use only powder coat on their products. Install time is an estimated 35 minutes and requires 18mm and 3/4" wrenches and 1/2" drill bit.
James S.
Reviewed in the United States on February 5, 2024
Front hitch
Brian W.
Reviewed in the United States on November 3, 2020
Did just what it was supposed to
Gerald Hoskins
Reviewed in the United States on August 19, 2019
I have not installed yet, looks good and arrived complete.
Kathleen Glenn
Reviewed in the United States on April 4, 2019
Fit and worked well but one of the proprietary components were missing
JB
Reviewed in the United States on March 23, 2016
Difficult installation due to bolt holes not lining up, but once that problem was solved it is a good hitch at a very good price.
Customer
Reviewed in the United States on November 9, 2016
This front mount receiver fit a 1999 Ford Ranger 4X4 perfectly. I was able to install the receiver in less than two hours in my driveway without any problems.
D F Barger
Reviewed in the United States on March 24, 2015
Met all of my expectations. However, because of its weight the cardboard packaging was stressed, ripped and exposed the unit to some abrasions-lost some paint. All parts arrived because they were taped to the unit.
Vidar Kahumana
Reviewed in the United States on February 6, 2015
Great hitch receiver! Installed on a 1998 Ford Ranger. Whoever designed the bolt on method for this hitch is a genius. It took a bit to figure out. I drilled out the smaller bolt holes with a 1/2" cobalt bit. It would be very helpful to use a drill with a brake. I nearly broke my wrist drilling the holes. When you get to the end it wants to catch and rip the drill out of your hands. At first I was worried that there was not a large enough opening to fit the bolt heads through. I found a large enough (round) opening on the inside of the frame toward the rear. I fished through the wire and dropped the rectangular pieces over the wire into the proper holes. Then re-fished the wire up through the bolt holes, through the rectangular metal pieces, and out through the large round hole. Screwed the bolts onto the wires and pulled them back through the holes. Once I figured out the first few the rest was easy.
Recommended Products
$29.95
$ 13 .99 $13.99