Your cart is empty.
Your cart is empty.Des:
Features:
Billet aluminum column shifter, tilt lever, turn signal lever, hazard knob kit.
All levers and knobs are made from billet aluminum and, polished.
Shafts are made from stainless steel and polished to match.
Fit for Original gm Columns 1967 to 1994
Fit for Chevrolet Buick and Cadillac
These are aftermarket columns that fit for GM 1967-1994 column, do not fit van columns.
How to Install:
1) Locate the bottom of shifter lever.
2) Drive the rivet out slowly. Be careful there's a spring, don't let it goes flying when removing.
3) Gently remove lever. Get a pin out.
4) Install back new lever. Same way to replace the turn signal and tilt lever.
Customer
Reviewed in the United States on March 6, 2025
works good
William jones
Reviewed in the United States on February 13, 2025
Did not work on my 96 gmc 1500
D & M
Reviewed in the United States on January 5, 2025
LMC sell thes for a lot more money. I used these for my 87 Suburban and shifter has a nug fit but works well since ny original shifter was kinda worn out, its definitely an improvement.
Michael Taylor
Reviewed in the United States on December 20, 2024
Worked great
ilija kovacevic
Reviewed in the United States on December 19, 2024
None of these parts fit at all even after being told these would fit the vehicle! Absolute garbage!!!
S
Reviewed in Canada on October 26, 2024
All scratched and knicked up
shane knight
Reviewed in the United States on April 15, 2024
Can’t use the turn signal one without deleting cruise control and wiper functions and the hazard threads are wrong… the shifter and tilt wheel are good though
Recommended Products