Your cart is empty.
Your cart is empty.Magnetic float switch used for a secondary drain pan. Prevents condensate overflow causing water damage and costly repair. Magnetic float switch is incredibly easy to install. Can be mounted to the drain pan in less than ten seconds. Does not require any pre-drilling for screws. Magnetic float switch incorporates a protective cover to keep out insulation and debris that could prevent the float from rising. Easy access for maintenance and cleaning. 5 Amp; 24 Volt AC magnetic float switch. Installed directly to the secondary drain pan; wiring inlcuded. FOR THE TRADESMAN: RectorSeal is recognized as a leading provider of quality solutions for the professional trades serving heating, ventilation, and air conditioning (HVAC/R), plumbing, electrical, and construction markets.
dave
Reviewed in the United States on August 1, 2024
JUST WHAT I NEEDED.
William A
Reviewed in the United States on July 19, 2024
Very easy to install onto my overflow drain pan.
G. Gilmore
Reviewed in the United States on October 9, 2024
easy install and perfect replacement for older broken model
Montyjb
Reviewed in the United States on January 12, 2024
Saved me $100 by not requiring HVAC tech to install.
William Dillon
Reviewed in the United States on February 20, 2023
We needed to add one of these for the sale of our house. It came quickly, was easy to install, and took care of the issue. Sale completed!
Customer
Reviewed in the United States on November 7, 2023
Muy facil de instalar y muy buena calidad👍🏼
Hector
Reviewed in the United States on November 23, 2023
I like this part
Samuel K. Ingram
Reviewed in the United States on September 21, 2022
Well, I tested this by clipping it onto the side of a plastic food storage container and gradually filled the container with water at my sink, while watching the wires with a resistance meter. It waited until the VERY last minute, but it did trip before water spilled over the side. So, when you install this make really sure you push it all the way down so the brim of your pan is seated all the way up into the mounting bracket. If your pan isn't deep enough for that (i.e., if the switch is stopped by the bottom of the pan instead of by the bracket, then be sure you do your own test; I'd worry in that case.I installed this in the drain pan for an Aprilaire whole home dehumidifier - installation was a breeze. On the wiring panel for the Aprilaire there are two terminals for float switch, and initially there is a small jumper between them. So you want to use the "common" and "normally closed" wires of the switch, which are the long one. I just removed the little jumper and wired the switch wires in its place - job done.
Recommended Products
