Your cart is empty.
Your cart is empty.Product Description
Customer
Reviewed in the United States on February 11, 2025
worked perfect 08 rebel 250 cc. converted everything to led.
Vittorio
Reviewed in Italy on February 1, 2025
Funziona sia con frecce normali che a led, è sufficiente regolare il lampeggio col dimmer
pierrick
Reviewed in France on January 29, 2025
Impeccable
Robert
Reviewed in the United States on January 24, 2025
Amust for leds
Cliente
Reviewed in Spain on January 19, 2025
Instalado en una YBR125 de 2006.Funciona a la perfección. Poner y a funcionar. Bombillas normales pero regulando velocidad valen para LED.Encima vienen 2 unidades.
david o.
Reviewed in the United States on September 14, 2024
Works, other types didnt, this one did!
johnk73
Reviewed in the United States on May 30, 2024
These flashers allow you to convert your vehicle to LED lights, without using load resistors. Part of the reason for switching to LEDs is to not run down your battery!Quite a bargain for two of them, and you can adjust the blinking speed to your preference.Worked for my turn indicator. But the hazard flasher was wired backwards. So it didn't flash at all; lights were black. Good news is that polarity reversal plugs are sold on Amazon.What these don't do is make a clicking sound. Sure my dash is flashing when I neglect to turn off my blinker, but sometimes I don't notice.So I upgraded to an LED flasher that makes a clicking sound. Though it cost three times as much, and required hooking up a ground wire. (And I still had to buy a polarity reversal plug.)
Hans
Reviewed in the Netherlands on March 16, 2024
Gebruikt op mijn ZZR1100d motor. Een driepunts aansluiting waar dit tweepunts relais het prima op doet. Snelheid van knipperen ook nog in te stellen!Lage prijs en snel geleverd
handykapped
Reviewed in the United States on November 16, 2024
Works perfect, it got rid of the hyper flash when I put LED turn signals on my Motorcycle.
anthony t.
Reviewed in the United States on May 14, 2023
these flashers work excellent on 2016 and 2019 honda grom led blinkers. fixed the problem of not blinking at all. easy to install and did not have to adjust them.
JeffK651
Reviewed in the United States on March 22, 2022
Update: The first one failed after 5 months. It was a 2 pack so I installed the second one and my turn signals work again. Will update again when the second fails.I installed this on my BMW f650gs. The flasher that was in the bike was flashing at varying speeds and sometimes not at all if my fog lights were on. Installing this fixed all the problems, now the lights flash all the time at the same speed regardless of which accessories are on. My one gripe, and I took one star off for this, the speed adjustment screw should be on the top and not on the bottom. There is no way I could adjust the speed while connected, luckily I was happy with the speed it came set at because there isn't much room to work with on my bike and I didn't want to unplug it and plug it back in. A bit of advice to my fellow f650gs riders, before installing this get two pairs of spade connecters and make up some 2 or 3 inch extension leads in advance. This will make installing and adjusting the speed much easier.
Customer
Reviewed in the United Kingdom on November 16, 2022
Works just as intended as a replacement for the original indicator relay on my Honda CBF125 (2014), which uses normal bulbs in the indicators, no LEDs. The flashing frequency was reasonable out of the box, so I haven't tried changing it so far - meaning, I can't comment on whether that works as it should.Changing the relay was extremely straight-forward, figure out where it is located on my bike, unplug the old relay that has packed it up, plug in the new one, done.Btw - if your bike has a 2-pin relay and some unspecified indicator issues, try shorting the wires connected to the old relay (after unplugging it). If it's just the relay that's bad, the indicators should now work, just showing a steady light instead of flashing. If they still don't work, you might have to keep looking for the real reason for your problems.
Jason Idleman
Reviewed in the United States on April 26, 2022
I have a fairly customized rat rod CB 360 Honda that I custom built the wire harness. I've tried several of the electronic flasher relays. Most would work fine for a day or so then would stop working and the signals wouldn't flash. It's only been a couple of weeks, but after installing these my turn signals work perfectly
Recommended Products