Your cart is empty.
Your cart is empty.Axle Hat Nuts, also called cap nuts, are not threaded and are held in place by an inward facing contact points. They can be installed by gently tapping into pace using a hammer or mallet. Hat nuts are most often used to hold wheels in place on dollies/hand trucks, carts, pressure washers, air compressors and etc.
Kevin Schreur
Reviewed in the United States on February 29, 2024
garbage
Karl E Batig
Reviewed in the United States on February 14, 2024
I would say these are useless. They must be mild steel or something because they push onto the axle then fall off. No holding power.
Craig Roberts
Reviewed in the United States on July 31, 2023
Barely works
Robert
Reviewed in Canada on July 23, 2023
these work fine need a firm push on shaft but will not fall off.
Gene Sloan
Reviewed in the United States on February 28, 2023
Replacing axle push caps on a restore of a Tonka toy pickup turned into a not so simple finish to my restore project. I put them on with a small socket, with a couple of taps and I thought they were on. Change to the opposite end of the axle, do the same thing and the other side is loosened, maybe stretched. They can't be trusted. I'm looking for a threading die, and I'm going to put threaded nuts on, instead. These Primeline push caps are not good quality.
Newdock
Reviewed in Canada on February 20, 2023
Poor manufactures tolerance. Poor quality. Several just came off, didn't bite the metal rod. Probably threw about half the package out, wouldn't buy again.
Joseph Kintgen
Reviewed in the United States on December 28, 2022
Perfect fit.
Mickey
Reviewed in Canada on December 17, 2022
Push nuts would not hold. They kept falling off. Waste of time and money
Terry RANKIN
Reviewed in Canada on December 1, 2022
Have not used just yet But it will be used to restore my vintage TONKA Toys. just waiting for paint to finish.
Billy
Reviewed in the United States on November 30, 2022
Worked fine for my Tonka restoration.
Customer
Reviewed in Canada on November 3, 2022
The media could not be loaded.
Dave
Reviewed in the United States on November 11, 2021
These were sold as axle hats to fit a 3/16" shaft. The opening on these axle hats are 3/8" and do not fit.
Recommended Products
