Your cart is empty.
Your cart is empty. Designed to fit 5/8 inch hand truck axle shafts, these push-on pushnuts are perfect for most hand carts and wheel replacement parts
This 10 pack pushnut serves as both a retainer and fastener for low-torque wheels, providing a balance between strength and durability
The spring force produced by its teeth allows the pushnut to create more friction between itself and the shaft increasing its rotational resistance
The black coating on these pushnuts is a zinc phosphate coating with an oil sealer. Zinc phosphate coatings strongly adhere to surfaces either through immersion or spray
Tenmile
Reviewed in the United States on February 1, 2025
I tried installing no fewer than five of these before I gave up. Each one split and broke apart as I tapped it gently into place.
Patrick Craig
Reviewed in the United States on January 21, 2025
Well I went through 4 of them all splitting in half. To say I am disappointed is an understatement. Save your money, buy elsewhere.
Scott Nuechterlein
Reviewed in the United States on January 13, 2025
These push nuts work well to hold dolly wheels on the axle. They’re very easy to install. When installing them use light taps with a hammer. If you hit them too hard they’ll split apart, which is the case for any brand of these you’re using. I usually put them on far enough to allow for just enough play that the wheel still spins freely. The flat side goes against the wheel. They’ll hold up until you need to replace the wheel, which in some cases they can be reused or you’ll have to put a new one on. They are plenty thick, they fit perfectly and are a great value for the price.
SandyEggo
Reviewed in the United States on January 11, 2025
I tried to put on just one axel and it broke in half. I tried 2 more times, both of those broke in 2 pieces as well. They are the right size but too brittle. I give up. Returning to Amazon
PugMomof3
Reviewed in the United States on December 31, 2024
Must have if you are replacing wheels on a dolly.
Recommended Products
