Your cart is empty.
Your cart is empty.Product Description
High-quality materials:
Made of high-grade 316 stainless steel and high quality ceramic pressure chip, it can work perfectly in various environments.
Voltage Signal Output:
0.5V – 4.5V linear voltage output. 0 psi outputs 0.5V, 50 psi outputs 2.5V, 100 psi outputs 4.5V.
High Precision
±2%FS small output error, full temperature range, high sensitivity and accuracy
Voltage Protection
Complete surge voltage protection function, safe for use
100 PSI
5 PSI
30 PSI
Customer
Reviewed in the United States on March 3, 2025
Ordered two of these and one failed after the return window had closed.
Angus Stewart
Reviewed in Canada on February 18, 2025
Used to replace the one for my glow shift 30psi gauge and it worked I had the re-wire the original glow shift harness and solder onto this connector but works with the gauge been using if for a few months and all seems good!
MR
Reviewed in the United States on January 4, 2025
The pressure transducer worked great fro my LS swaped Trans am to run my aftermarket gauges. It was nice to have the wire pigtail.
Jared Yandle
Reviewed in the United States on August 12, 2024
I have tried these from three different sellers. They have all worked fine, but failed after a short amount of use. These were installed to read boost pressure on my marine diesels. They are in a very clean engine room environment.They worked perfect for 4 months, then both of them died almost at the same time.
Blueman2
Reviewed in the United States on June 25, 2024
Installed on my pool filter using a 1/4" brass Tee and a 1/8 to 1/4" brass converter. Pretty simple. Used Raspberry Pi with ads1115 voltage A/D board so that Pi could read the pressure and send to my Home Assistant program. Very accurate.
D. M. Reavis
Reviewed in the United States on May 3, 2024
This is an inexpensive part, but works fine and arrived on time. I measured the current draw at about 2.35ma continuous, could be used battery operated, would be fine for low pressure air line, water line, etc. Accuracy ok for most uses. Connector is nice, would be about the same as the whole sensor if purchased separately.
SpeedD408
Reviewed in the United States on March 21, 2024
I'm using this as a test 300 psi transducer for my transmission pressure Arduino project. It works very well for that purpose but once I am done and everything is installed I will pay the money for a more accurate unit.
Elliott M Sting
Reviewed in the United States on November 18, 2024
I used this with an Arduino. There's a bit of bounce in the readings, but it's reading reliably and working well.
Sam E.
Reviewed in the United States on October 13, 2024
I use these for all my Holley terminator swaps
Recommended Products