Your cart is empty.
Your cart is empty.pressure switch is factory set to 95-125. Switch comes with unloader and on/off SWITCH. 1/4" female NPT connection
Chris Sack
Reviewed in the United States on April 8, 2024
I installed this pressure switch on my compressor, and it is working great.
Cook
Reviewed in the United States on November 10, 2023
Two years ago, my old Craftsmen compressor needed a new pressure valve. I bought a Hubbell 69JF7LY, which failed just recently. This switch replaced the Hubbell directly, worked perfectly out of the box, and I hope will provide 30 years of service like the original instead of the 2 years service that the Hubbell replacement did. In all visible aspects, this switch seems to be of equivalent quality to the Hubbell. In fact, I like the on-off switch with a nice red lever better than the almost invisible black lever on the Hubbell. Only time will tell if this switch will last longer.
Gregg L
Reviewed in the United States on August 27, 2021
I am not sure if you can get it with a male end. So i added a 1 inch nipple to connect it to the compressr
DNL
Reviewed in the United States on August 3, 2019
About as close a direct replacement as you could expect, replaced an old Craftsman compressor switch and it fit perfectly. Only had to route the wires differently which was not a problem. The pressure switch was set perfect right out of the box. Ordered and got it in one day using Prime.
Tony
Reviewed in the United States on October 1, 2019
Good inexpensive replacement pressure switch for my old craftsman air compressor. Works as the old one did and easy to install. The only thing I did not like is how the electrical wire is held in place, the old one had a screw in clamp to lock the wire in place but this one has a rubber grommet that hols the wire in place but unfortunately the wire slowly slides out so I had to add a clamp to hold it in place. If it wasn't for the wire attachment I would have given it a five star.
Sprucegreen14
Reviewed in the United States on April 15, 2019
Hard to adjust
Veronica
Reviewed in the United States on September 13, 2018
The unit was as described. Quality built and met every need. Supplier put it in the mail almost as soon as ordered. USPS got it hung up in Texas for 4 days or I would have had it in 2 Days. Would recommend it to anyone who needs this.
Customer
Reviewed in Canada on October 28, 2018
You may need a 5/16” adaptor to screw into the unit.
Keystone Kid
Reviewed in the United States on April 23, 2016
This switch was a perfect replacement for my old Sanborn 2HP 22 gallon compressor with model number 104CB200-22 (Commercial model) same as 104B200-22 model. Old switch was a Furnas #034-0038 Switch only uses two wires (hot & neutral) from the electric motor. Line from air pressure pump to pressure switch unloader, fit exactly without need for modification. I highly recommend this pressure switch and vendor.
Recommended Products
