Your cart is empty.
Your cart is empty.TECHNICAL INFO SHOWN BELOW. Range of product Square D Pumptrol Pressure sensor name 9013FH Pressure sensor size 150 psi Value of setting Off at 125 psi Electrical circuit type Power circuit Product specific application Control small electrically driven air compressors Quantity per set 1 Type of packing Individual Complementary Pressure sensor type Electromechanical pressure switch Controlled fluid Air (-22...257 °F) Adjustable range on rising pressure 70...150 psi Approximate adjustable differential 30 psi Destruction pressure 220 psi Pressure actuator Diaphragm Pressure switch type of operation Regulation between 2 thresholds Scale type Fixed differential Setting Internal Local display Without Contacts type and composition 2 NC, snap action, DPST-DB, Form YY Cable entry number 2 0.88 in cable entries with 0.84 in across flats UL 508 Electrical connection Screw-clamp terminals, clamping capacity: 5.261 mm² Screw-clamp terminals, clamping capacity: 10 AWG Fluid connection type 0.25 inch NPSF internal conforming to UL 508 Short circuit protection 20 A by cartridge fuse, type gG Materials in contact with fluid Nitrile (Buna-N) or equivalent rubber diaphragm Zinc plated steel or equivalent flange Material Noryl thermoplastic resin or equivalent cover Polypropylene cover Operating position Any position Motor power kW 0.75 kW (1 hp) at 575 V AC, 3 phases 0.75 kW (1 hp) at 460 V AC, 3 phases 2.2 kW (3 hp) at 230 V AC, 3 phases 1.5 kW (2 hp) at 115 V AC, 3 phases 1.1 kW (1.5 hp) at 115 V AC, 1 phase 1.5 kW (2 hp) at 230 V AC, 1 phase Electrical durability 100000 cycles at 10 cyc/mn Mechanical durability 300000 cycles Terminal block type 4 terminals Operating rate 10 cyc/mn [Ui] rated insulation voltage 575 V conforming to UL 508 Product weight 1 lb(US) Repeat accuracy +/- 3 % Terminals description ISO n°1 L1-T1 L2-T2
christopher giaquinto
Reviewed in the United States on January 2, 2025
my 40-year-old air compressor pressure switch burnt put finally and I needed a replacement because i didn't want to buy a new air compressor because they don't make em like they used to1 found this on here and ordered it and it worked perfectly! as far as some reviews saying the shut off arm felt cheap and tight? well all you have to do is loosen the nut closest to it and it makes the lever go up and down easier!
Customer
Reviewed in the United States on September 7, 2024
I installed this on my Quincy air compressor and I am quite satisfied.
steven siefker
Reviewed in the United States on October 8, 2024
can tell the high quality by the weight
Jody Moore
Reviewed in the United States on April 4, 2024
I bought this to put on a non working compressor I purchased a few weeks ago. It had several issues and this was one of them. This worked great and was a perfect replacement for the original part. Good quality and worked correctly out of the box. No adjustments needed at all. Highly recommended.
Dan M.
Reviewed in the United States on April 1, 2024
Yeah, it's great. It works as it should. It arrived when it was supposed to. The box was creamed because the box was shipped in an envelope, so it had no protection. Fortunately, the pressure switch lived through it.
Gymnast
Reviewed in the United States on August 10, 2023
Had previously installed this one 2 years ago, was leaking now from diaphragm gasket even after I tightened it 3 month ago. Bought this one again and hope it lasts more than 2 years. Only complaint is the screws on the switch to connect the wires were way too tight. Had to use a hand impact screwdriver to get one loose. Bent a couple times but I bent it back without breaking. I always liked Square D products in the past.
Customer
Reviewed in the United States on May 3, 2023
Easy install, replaced the old Furnace switch and re-piped my 60gal stand-up. Works like a champ!
Jon
Reviewed in the United States on June 29, 2020
* The switch fit very well and did everything the old switch did.* It has a pressure cut off range of 95 to 125 lbs. and IS easily adjustable.* It has a shut off handle that others say is flimsy, but the tension on the handle is adjustable.* Switch comes with easy to understand wiring instructions.* The first picture shows the switch internal components. To adjust the cutout pressure, turn the center spring top nut counterclockwise to reduce pressure and clockwise to increase.* If the cutoff handle is too hard to move and feels like it is going to break off, adjust it. Turn the spring nut on the right of the picture that attaches to the handle, counterclockwise to reduce tension on the handle.* Center picture is the final wiring and the last picture is the fully installed working switch.* Great item at a good price. Comes with instructions.* I recommend this switch and would buy it again. jon
Recommended Products
$190.00
$ 92 .99 $92.99
$20.99
$ 10 .99 $10.99