Your cart is empty.
Your cart is empty.The SAMG series water separator is installed on the air pressure line to remove water drops from compressed air; water removal rate is 99 percent. It is available in 7 sizes with a variety of optional combinations to meet your application requirements. Installation Install units so the airflow is in the direction “IN-OUT” as indicated by arrow on the head of the unit. Install water separator as close as possible to the pneumatic equipment, tools, or appliances being serviced. Water Separator must be installed in vertical, downstream position for proper function. In most cases, an SAF particulate pre-filter with a 10 micron element is recommended to greatly extend the life of the element. When the element becomes clogged with dirt, it must be replaced. A pre-filter will remove water and dirt before it reaches the Water Separator and will reduce maintenance costs. Do not install polycarbonate bowl in pressure that exceeds 150 PSI or where there is a presence of solvents harmful to polycarbonate. In these cases, use a metal bowl. Operation & Adjustments SAMG, Water Separators eliminate water droplets up to 99% in compressed air line systems, pneumatic equipment and tools. Filter element should be replaced after 2 years of using or when pressure drop exceeds 10 PSI (1.0kgf/cm²). Operating the filter at a pressure drop in excess of 10PSI will greatly reduce the efficiency of the filter. If oil appears downstream: 1) check downstream air lines to be sure that they are free of residual oil; 2) check to see that the O-ring of the filter element is in good condition and installed properly.
Mary Brito
Reviewed in the United States on July 29, 2019
I refinish furniture for a living. Installed this unit in addition with the air cleaner and did not clean my lines. I still see alot of water droplets in the clear air tubing into my spray gun. Very disappointed and a waste of money. I ended purchasing little disposable filters you change every week and attached it to my gun. Worked much better and no debris or water in my finish.
JH
Reviewed in the United States on May 22, 2019
I replaced a 3/8" unit, installed in 1/2" tuning with this. It allows me to maintain higher pressure in my system.
Dave n
Reviewed in the United States on March 31, 2019
I bought two and after using the cheap ones these are worth the extra cost very well made
Harold P.
Reviewed in the United States on October 16, 2017
Perfect!
JLP
Reviewed in the United States on May 4, 2016
Nice made item. Works well and mounting bracket is thick enough that it will hold the unit without bending unlike some other options our there.
Willie g
Reviewed in the United States on November 28, 2016
I have two of them work well from keeping water out of compressed air lines
Nicolas Alvarez
Reviewed in the United States on February 23, 2015
by the book
James A.
Reviewed in the United States on November 17, 2014
Great seperator for the price.Timely delivery
Recommended Products
$14.85
$ 6 .99 $6.99