Your cart is empty.
Your cart is empty.This garbage disposal kit has all components needed to install a garbage disposal. It includes - (1) 1-1/2 inch OD x 6 inch flanged tailpiece, (1) 1-1/2 inch OD x 14 inch flanged tailpiece, (1) 1-1/2 inch OD x 7 inch slip joint drain arm, (1) slip joint end outlet tee, (1) 90 degree elbow, (1) rubber connection boot with barbed Adapter & clamps, (1) 1-1/2 inch OD wall drain trap, (5) 1-1/2 inch I. D. Polyethylene washers and (1) reducing washer.
Ej
Reviewed in the United States on February 11, 2025
Perfect pieces to replace older pipes.
Maka Makalena
Reviewed in the United States on January 26, 2025
I bought when I ordered my new disposal. Changes everything at the same time.
Margaret Thomas
Reviewed in the United States on September 7, 2024
Got enough to do the job. But this product came with a open bag and missing three items.
Daniel Sherer
Reviewed in the United States on July 29, 2024
My old disposal died and since I was replacing it, I decided to also upgrade the old plumbing under my sinks.The previous plumbing was all "flexible" joint, which seems to trap bits of food/junk, causing it to drain slowly. This kit came with everything I needed (a few extra pieces, actually). It was cheaper (not to mention easier!) to get this kit w/extras than to go to a store and buy pieces individually.You (most likely) will need to cut some of the longer pieces down using a hacksaw. For the straight pieces (where there's no threading on the end) you can easily trim the pipes down for a perfect fit. I had to do that on the pipe that connected the two sinks as (I guess?) my two sinks were an inch farther apart than one of the other pieces could reach.Easy to assemble and NO LEAKS!
Robert C.
Reviewed in the United States on July 13, 2024
Seem like quality parts would buy again
David A Smith
Reviewed in the United States on December 14, 2024
This is just a bag of plastic plumbing parts. Nothing special, but it contained everything I needed (and a lot I didn't need) to install our garbage disposal. The time and expense of driving to the home center would have been more than the cost of this bag of parts.
Psycho Eddie
Reviewed in the United States on October 20, 2024
Perfect fit and easy to install. There is no directions that I could find, so when replacing you old pipes take you time measure correctly and you'll be just fine during the install.
Andres Marcelo
Reviewed in Mexico on March 9, 2023
Se adapto a mi triturador
Gini Kibe
Reviewed in the United States on April 29, 2022
Worked great for us when installing a new garbage disposal.Good to keep one of these kits around the house for most kitchen sink drain problems and some of the later 1.5" inch codes on vanity sink drains sizes etc...when or if something leaks or have normal sink drain issues, this kit can help you and save you a service call to boot. It's easy to work with!Definitely save ya a trip to the Hardware store, will save you a headaches during afterstore hours episodes, like on a Sunday or after daily store hours when most local mom & pops hardware store are closed for the night etc...It's Inexpensive Sink Drain Help in a bag.However, Must use with a pair of med or large pair of channel lock pliers "not included" to firmly tighten up joints, nuts or couplings. Then run a little water & check for drips or leaks on the fittings.(Quick Note: this is a plastic or pvc product, so be careful & don't over tighten the nut fittings & you're good to go!)Hope that helps you in a punch! 😁Thx PF WaterWorks!
Recommended Products
$42.99
$ 22 .99 $22.99