Your cart is empty.
Your cart is empty.Flame-Thrower III coils feature a ultra low resistance and are designed specifically for the new Ignitor III ignition system. Flame Thrower III coils have a high turns ratio and ultra low primary resistance enabling the ignition system to charge faster at high RPM’s.
Scott Carlisle
Reviewed in the United States on August 26, 2024
I bought the flame thrower III coil with a flame thrower distributor to upgrade my ignition on a 69 GTO. After less than 100 miles, my car started misfiring bad when it warmed up and completely died on time while going down the road. After testing everything, the coil was dropping out when it got hot.Amazon support window was closed so I reached out to Pertronix. Anthony S. at Pertronix didn’t give me the time of day to help in any way. Basically told me to contact Amazon that it was their problem. Not only did I get a junk part but now I’m stuck with it without any support. Just saying, you should learn from my mistake of buying Pertronix products.
joseph chi
Reviewed in the United States on May 18, 2024
I installed this coil when I changed my distributor to electronic ignition. It works great.
andreas h.
Reviewed in the United States on December 9, 2024
Replaced the stock coil together with an Ignitor 3 module.Pricy (4 stars) but works.
Luis
Reviewed in the United States on November 17, 2024
Excellent
Dan Schall
Reviewed in the United States on January 23, 2024
It is a flame thrower, engine starts and runs much better than before. I would buy again
B
Reviewed in the United States on September 18, 2023
Great price, smooth start, very durable, and performed well on the fist star in a 56yr old Conti
jm
Reviewed in Canada on October 6, 2022
The Pertronix packaging is a little lite/flaky for the weight of the coil.Mine fell out thru the bottom of the box, onto the cement garage floor and chipped the tower a bit.Installed it anyway with the Ignitor 3 ignition module.1974 Olds Delta 88 Royale Convertible has never run so smooth or with as much zip!
Grant W.
Reviewed in Canada on May 27, 2021
Came damaged. Have not tested to see if it works but it has some dents and damage to the paint. The box looks like it has been crushed. I am still waiting on other parts to be delivered before I can test it but other than the damage it looks like a decent product.
Gerry Sanderson
Reviewed in Australia on May 25, 2021
Works great with electronic ignition
Customer
Reviewed in Canada on September 5, 2020
Works fine with ignitor 3, looks great
Robert
Reviewed in the United States on August 30, 2020
I decided to use oertonix in my 1969 Z28. All original car. You MUST run a 12v ignition switchable voltage to the coil. Otherwise the pertonix will drop out above 4000 RPM on Low voltage. You also MUST use this coil. If u try to use a stock coil! Ohm reading g is too high. Again. Pertrox will drop out at around 5000 RPM. This solved all my problems.
Customer
Reviewed in Canada on August 18, 2019
Not used yet but have used them before on other cars worked well
BWillie
Reviewed in the United States on July 3, 2019
Used with the Pertornix III and this puts out a very hot spark. Bright blue spark especially with the .007" over std. expanded gap. You must make sure you are getting a true 12V to the coil. If your car has a resistor or a resistor wire installed, you must remove them. This is not difficult to do. The Pertronix III is awesome and works far better than I expected !!!! I will be converting ALL of my vintage cars to this system when my wallet stops bleeding !!
Recommended Products
