Your cart is empty.
Your cart is empty. The diy clock hands replacement Kit is a good replacement. suitable for cross-stitch, three-dimensional embroidery, craft clock, frameless draw clock,12888, etc. Suitable for repairing, replacing, and also suitable for diy various styles of the clock frame.
Specification
Material: Aluminum
Suitable for Shaft diameter of the movement Hour hand: 3.6mm / 0.14inch
Suitable for Shaft diameter of the movement Minute hand: 5.5mm / 0.22inch
Package List: 10 Set Clock Hands Kits
Length from hole to needle tip:
Hour hand: 62mm / 2.44inch
Minute hand: 95mm / 3.74inch
Second hand: 90mm / 3.55inch
Advantage
1. Mute clock mechanism: The clock hand adopts a super silent scanning design, providing a quiet environment for your sleep.Time accuracy: The error in a day is within 1 second.
2. Durable material: These clock hands are made of aluminum, safe and durable, with good corrosion resistance, lightweight, and can be used for a long time.
Instruction: Place the hour hand, minute hand, and second hand at the twelve o'clock position in the order. Please note that the hour hand should remain flat during the installation process
NOTE: Do not use excessive force when installing, or it will bend.
David
Reviewed in the United States on June 7, 2025
Works well with most of my clockworks.
DjjZ
Reviewed in the United States on May 3, 2025
These seem fine but check the measurements, as they are two short for my 16" patio clock. After looking at the listing again, I see it was my mistake.
chocolate
Reviewed in the United States on July 9, 2024
White stands out
Kelly Williams
Reviewed in the United States on December 15, 2024
Items to small
Recommended Products
