Your cart is empty.
Your cart is empty.3.7 out of 5 stars
- #351,291 in Patio, Lawn & Garden (See Top 100 in Patio, Lawn & Garden)
- #918 in Automatic Irrigation Accessories
This Orbit 37164D swing-joint elbow pipe fitting is made to install garden sprinkler heads to in ground sprinkler pipes. This sprinkler pipe fitting has a 3/4-inch MNPT (Male National Pipe Thread) connection and a 3/4-inch FNPT (Female National Pipe Thread) connection for many different pipe fitting uses. This Orbit 37164 sprinkler part attaches to poly pipes and PVC irrigation pipes to create swing joints for attachment to yard sprinkler system heads. This is an ideal piece of sprinkler syst...
VH
Reviewed in the United States on September 13, 2023
It’s not a bad product but for some reason the distributor adhered a paper barcode to each elbow so it takes about 20 extra minutes to remove all 5 barcodes.
allen perry
Reviewed in the United States on July 12, 2023
this very inexpensive small piece came in very handy when using it on my small garden pond that I have the local hardware store didn’t have it in stock and I got it next day from Amazon for less than a dollar. It has been holding up very well under the pressure of the water in my pond, and I’m very impressed by the durability and good quality of this product
Shirley
Reviewed in the United States on March 30, 2023
I used the first one to connect to a straight hose and it stripped out. Not meant for metal connections.
andrew
Reviewed in the United States on August 4, 2022
Will upload photo. Been doing landscape construction almost 30 years. Last job large irrigation system. No exaggeration.. out of 80 sprinkler heads about 40% of this part failed in exactly the same spot, right on a seem in however they are molded. Never seen anything like it. So the amount of time ive had to spend chasing around these fittings as they all crack and fail in same spot has been maddening to say the least. I purchased through home depot but they are orbit brand. I hope they fix this problem, id be willing to bet there are alot of upset irrigation contractors out there. In last 5 years the quality of most all plastic fittings has completely gone down the toilet. The failure rates on so many PVC parts has shot through the roof. This last one takes the cake.
Paul P.
Reviewed in the United States on July 19, 2022
Fit good
Jerry R Smithson
Reviewed in the United States on May 7, 2022
Item was exactly what I needed and could not find in box stores.
Harley2000
Reviewed in the United States on September 8, 2021
Well made product and fit correctly.
Peng Chen
Reviewed in the United States on October 7, 2019
This Orbit 37164 Elbow Swing-Joint 90 is 3/4 inch in size and fit my dehumidifier drain perfectly. I have a washer hose in hand and try to use the washer hose to drain humidifier, but the washer hose has smaller ring inside that lift the water level by 5 mm, and this lift sent the dehumidified water back into tank. To use the continuous water drain, you have to use dehumidifier water hose that has no lip at the connection. After connect this elbow to the dehumidifier, then connect my washer hose to the Elbow and points down, actually the problem is solved.
Recommended Products
